Home › Suspension › SUSPENSION CONTROL › FRONT ACCELERATION SENSOR
RM38G0E _53 Suspension _100546 SUSPENSION CONTROL _0472694 FRONT ACCELERATION SENSOR A

SUSPENSION CONTROL  FRONT ACCELERATION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C458554N01
0.083,0.083 6.167,4.75 6.083,4.667 5.25,1.667 5.25,1.25 5.25,1.25 5.417,1.25 false 1.25,3.885 1.25,4.219 1.25,4.219 1.417,4.219 false 3.125,4.292 5.542,4.292 5.542,4.292 5.542,3.375 false 3.583,4.292 3.583,3.875 false 6.531,0.219 6.865,0.219 false 0.167,0.167 0.583,0.5 0.417,0.333 10 false *A 6.375,0.094 6.625,0.427 0.25,0.333 18 false 1 1.469,4.104 1.719,4.438 0.25,0.333 18 false 2 5.469,1.125 5.719,1.458 0.25,0.333 18 false 3 2.906,4.125 3.156,4.458 0.25,0.333 18 false 4

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY 73900 - - -
3 ECU INTEGRATION BOX RH 82877 - - -
4 ACCELERATION SENSOR 89191A (Click here) - -

*A for LHD - -

C458557N01
5.25,1.667 5.25,1.25 5.25,1.25 5.5,1.25 false 1.25,3.917 1.25,4.25 1.25,4.25 1.5,4.25 false 3.115,4.292 5.531,4.292 5.531,4.292 5.531,3.375 false 3.583,4.292 3.583,3.875 false 5.552,1.115 5.802,1.448 0.25,0.333 18 false 5 1.552,4.135 1.802,4.469 0.25,0.333 18 false 6 2.917,4.135 3.167,4.469 0.25,0.333 18 false 7 0.167,0.167 0.5,0.5 0.333,0.333 10 false *A

Procedure Part Name Code
Z101186

Z101188

Z101187

5 POWER DISTRIBUTION BOX ASSEMBLY 82730G - - -
6 LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY 73990 - - -
7 ACCELERATION SENSOR 89191A (Click here) - -

*A for RHD - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the acceleration sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane tracing assist system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -




PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click here(Click here)



Hide 73900 2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD)

Hide 82877 3.REMOVE ECU INTEGRATION BOX RH (for LHD)

Hide 89191A 4.REMOVE ACCELERATION SENSOR (for LHD)

Z101186

NOTICE:
·

Avoid any impact to the acceleration sensor.

·

Do not drop the acceleration sensor. If it is dropped, replace it with a new one.




a.

for Driver Side:

C458555


b.

for Passenger Side:

C458556


Hide 82730G 5.REMOVE POWER DISTRIBUTION BOX ASSEMBLY (for RHD)

Hide 73990 6.REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)

Hide 89191A 7.REMOVE ACCELERATION SENSOR (for RHD)

Z101186

NOTICE:
·

Avoid any impact to the acceleration sensor.

·

Do not drop the acceleration sensor. If it is dropped, replace it with a new one.




a.

for Driver Side:

C458559


b.

for Passenger Side:

C458558