The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front differential side gear shaft oil seal removal/installation are shown below.
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the front disc brake pads, the brake pedal may feel soft due to clearance between the front disc brake pads and rear disc. Depress the brake pedal several times until the brake pedal feels firm.
After replacing the front disc brake pads, always perform a road test to check the braking performance and check for vibrations.
When removing or installing the front disc brake cylinder assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C13DB00, C13DC00, C13DD00, C13DE00, C140000 and/or C140A00 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this procedure.
While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
51441 1.REMOVE NO. 1 ENGINE UNDER COVER
51442 2.REMOVE NO. 2 ENGINE UNDER COVER
3.DRAIN DIFFERENTIAL OIL
43420 4.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
43410 5.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
Use the same procedure described for the LH side.
43420H 6.REMOVE FRONT DRIVE SHAFT OIL SEAL LH
Using SST, tap out the differential side gear shaft oil seal.
43410M 7.REMOVE FRONT DRIVE SHAFT OIL SEAL RH
Use the same procedure described for the LH side.
43420H 8.INSTALL FRONT DRIVE SHAFT OIL SEAL LH
| *1 | Differential Carrier | *2 | Front Drive Shaft Oil Seal LH |
| *a | Gap | - | - |
Using SST and a hammer, tap in a new front drive shaft oil seal LH.
0 to 0.5 mm (0 to 0.0197 in.)
Make sure that the lip of the front drive shaft oil seal is inserted into SST before tapping in the front drive shaft oil seal LH.
Do not damage the front drive shaft oil seal LH.
43410M 9.INSTALL FRONT DRIVE SHAFT OIL SEAL RH
| *1 | Differential Tube | *2 | Front Drive Shaft Oil Seal RH |
| *a | Gap | - | - |
Using SST and a hammer, tap in a new front drive shaft oil seal RH.
-0.5 to 0.5 mm (-0.0197 to 0.0196 in.)
Make sure that the lip of the front drive shaft oil seal is inserted into SST before tapping in the front drive shaft oil seal RH.
Do not damage the front drive shaft oil seal RH.
43420 10.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
43410 11.INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
Use the same procedure described for the LH side.
12.ADD DIFFERENTIAL OIL
51442 13.INSTALL NO. 2 ENGINE UNDER COVER
51441 14.INSTALL NO. 1 ENGINE UNDER COVER