| *1 | REAR DIFFERENTIAL CARRIER GASKET | *2 | REAR AXLE HOUSING FILLER PLUG |
| *3 | REAR AXLE HOUSING DRAIN PLUG | *4 | GASKET |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
|
Do not apply lubricants | - | - |
41110 1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
Clean the contact surfaces of the rear differential carrier assembly and axle housing.
Install the rear differential carrier assembly and a new rear differential carrier gasket with the 10 nuts and 10 washers.
The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.
Do not damage the installation surface when installing the rear differential carrier assembly.
The remaining oil may leak out when installing the rear differential carrier assembly.
Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.
Install the bolts with the rear differential carrier assembly secured.
2.INSTALL REAR AXLE SHAFT WITH BACKING PLATE LH
3.INSTALL REAR AXLE SHAFT WITH BACKING PLATE RH
Use the same procedure described for the LH side.
37110F 4.INSTALL REAR PROPELLER SHAFT ASSEMBLY