| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT WHEEL | - | - | - | - |
| 2 | FRONT STABILIZER BAR | 48811 | - | - | - |
| *1 | NO. 1 CAMBER ADJUSTING CAM | *2 | NO. 1 CAMBER ADJUSTING CAM ASSEMBLY |
| *3 | NO. 2 CAMBER ADJUSTING CAM ASSEMBLY | *4 | NO. 2 CAMBER ADJUSTING CAM |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front lower suspension arm removal/installation are shown below.
When disconnecting the front speed sensor LH, check that the wire harness is not entangled with other parts.
Use the same procedure for the RH and LH sides
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
48811 2.REMOVE FRONT STABILIZER BAR
w/ Electronic-Kinetic Dynamic Suspension System: Click hereSuspension>FRONT SUSPENSION>FRONT STABILIZER BAR (w/ Electronic-Kinetic Dynamic Suspension System)>REMOVAL
w/o Electronic-Kinetic Dynamic Suspension System: Click hereSuspension>FRONT SUSPENSION>FRONT STABILIZER BAR (w/o Electronic-Kinetic Dynamic Suspension System)>REMOVAL
89543 3.DISCONNECT FRONT SPEED SENSOR LH
5.DISCONNECT FRONT SHOCK ABSORBER WITH COIL SPRING
48626 6.DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH
48069 7.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
| *1 | No. 1 Camber Adjusting Cam | *2 | No. 2 Camber Adjusting Cam |
| *a | Matchmark | - | - |
Support the front suspension LH with a jack.
Place matchmarks on the No. 2 camber adjusting cam and No. 1 camber adjusting cam.
Remove the nut, No. 2 camber adjusting cam, No. 1 camber adjusting cam assembly, No. 2 camber adjusting cam assembly, No. 1 camber adjusting cam assembly and front lower No. 1 suspension arm sub-assembly LH.
48626 8.REMOVE FRONT LOWER BALL JOINT ATTACHMENT LH
| *1 | Claw A | *2 | Claw B |
Remove the cotter pin and nut.
Using SST, remove the front lower ball joint attachment LH.
Claw A 09955-04090
Claw B 09955-04031
48331E 9.REMOVE FRONT NO. 1 SPRING BUMPER LH
Using SST, remove the 2 front No. 1 spring bumper LH from the vehicle.