|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Use the same procedure for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
1.INSTALL GROMMET
53601 2.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
77306 3.INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
73900 4.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
| *a | Turns off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Engage the claw.
Install the lower No. 1 instrument panel airbag assembly with the 4 bolts.
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Make sure the lock button is securely locked.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
Check that there is no looseness in the lower No. 1 instrument panel airbag assembly.
55312 5.INSTALL LOWER INSTRUMENT PANEL
55395C 6.INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH
55432D 8.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
55318F 9.INSTALL NO. 2 INSTRUMENT SIDE PANEL
62112 10.INSTALL COWL SIDE TRIM BOARD LH
67914B 11.INSTALL FRONT DOOR SCUFF PLATE LH
55606 12.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 1GR-FE:
for V35A-FTS:
for F33A-FTV:
14. PERFORM DIAGNOSTIC SYSTEM CHECK
15.CHECK SRS WARNING LIGHT
16. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART