| *A | w/ Rear No. 2 Seat | *B | w/o Rear No. 2 Seat |
| *C | w/ Tonneau Cover | *D | w/ Carpet |
| *A | w/ Tonneau Cover | *B | w/ Rear No. 2 Seat |
| *C | w/ Curtain Shield Airbag | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear No. 1 seat outer belt assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
|
|
for 1GR-FE:
for V35A-FTS:
for F33A-FTV:
3.REMOVE REAR NO. 2 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat)
for Manual Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Manual Seat)>REMOVAL
for Power Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Power Seat)>REMOVAL
64910M 4.REMOVE TONNEAU COVER ASSEMBLY (w/o Rear No. 2 Seat)
58570C 5.REMOVE REAR FLOOR CARPET ASSEMBLY (w/ Carpet)
58410B 8.REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)
58418H 9.REMOVE REAR FLOOR BOARD REAR LH (w/o Rear No. 2 Seat)
58417B 10.REMOVE REAR FLOOR BOARD REAR RH (w/o Rear No. 2 Seat)
64993 11.REMOVE REAR DECK FLOOR BOX (w/o Rear No. 2 Seat)
58574G 12.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat)
67918D 13.REMOVE REAR DOOR SCUFF PLATE LH
73233D 14.REMOVE OUTER LAP BELT ANCHOR COVER
73370C 15.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)
73570 16.REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) (w/ Rear No. 2 Seat)
62520B 18.REMOVE QUARTER TRIM PANEL ASSEMBLY LH
62582E 19.REMOVE QUARTER PILLAR GARNISH LH
73370C 20.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
| *A | w/ Pretensioner | - | - |
|
Bolt A |
|
Pretensioner Connector |
|
Bolt B |
|
Bolt C |
Loosen the bolt A and remove the shoulder anchor of the rear No. 1 seat outer belt assembly LH.
w/ Pretensioner:
1. Disconnect the pretensioner connector.
Refer to How to Connect or Disconnect Airbag Connector:
Remove the bolt B and bolt C.
Detach the guide and remove the rear No. 1 seat outer belt assembly LH.