| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( ) |
- | - |
| 2 | DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL | - | - | - | - |
| 3 | DRAIN SUSPENSION FLUID | - | - | ( ) |
- |
| 4 | STEP SUB-ASSEMBLY LH | - | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 5 | REAR STABILIZER CONTROL TUBE ASSEMBLY | - | ( ) |
- | - |
| 6 | STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY | 48860D | ( ) |
- | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the stabilizer control with accumulator housing assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for V35A-FTS:
for F33A-FTV:
4.REMOVE STEP SUB-ASSEMBLY LH
5.DISCONNECT REAR STABILIZER CONTROL TUBE ASSEMBLY
Using a union nut wrench, disconnect the rear stabilizer control tube assembly.
Do not kink or damage the rear stabilizer control tube assembly.
Do not allow any foreign matter such as dirt or dust to enter the rear stabilizer control tube assembly from the connecting parts.
48860D 6.REMOVE STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY
|
|