Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2021.07
RM38G0E _51 Engine / Hybrid System _101082 CRUISE CONTROL _0469134 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise SET Indicator Light Circuit  


DESCRIPTION

The ECM illuminates the cruise control SET indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise control SET indicator illuminates when the cruise control system is controlling vehicle speed. The cruise SET indicator light circuit uses CAN communication. If the cruise control SET indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

CAUTION / NOTICE / HINT

CAUTION:

Observe the following items for safety reasons when using the GTS:

·
A356952

Before using the GTS, read the instruction manual.

·
A356953

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes, 2 people are required. One person should operate the GTS while the other drives the vehicle.



NOTICE:
·

Before replacing the ECM refer to Service Bulletin.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display (All) Completely illuminates the multi-information display ON Confirm that the vehicle is stopped with the ignition switch ON.
Body Electrical > Combination Meter > Active Test
Tester Display
Meter Display (All)
50004 409 277

Result:
Result Proceed to
The multi-information display in the combination meter assembly turns on according to the operation of the Active Test. A
The multi-information display in the combination meter assembly does not turn on according to the operation of the Active Test. B



A

2.READ VALUE USING GTS

B

2.READ VALUE USING GTS
a.

Turn the cruise control system on using the cruise control main switch.


b.

Drive at a speed between approximately 30 km/h (20 mph) or higher.


c.

Read the Data List according to the display on the GTS.

Powertrain > Cruise Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
-SET Switch -SET switch status ON or OFF ON: -SET switch pushed
OFF: -SET switch not pushed
-
Powertrain > Cruise Control > Data List
Tester Display
-SET Switch
50003 374 19

Result:
Result Proceed to
The cruise control SET indicator illuminates and turns off according to the operation of the -SET switch. A
The cruise control SET indicator does not illuminate but the Data List item -SET Switch changes according to the operation of the -SET switch. B
The cruise control SET indicator does not illuminate and the Data List item -SET Switch does not change according to the operation of the -SET switch. C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C