| *1 | FUEL TANK FILLER PIPE | *2 | PIN |
| *3 | FUEL TANK BAND | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
77697A 1.INSTALL NO. 2 FUEL TANK HEAT INSULATOR
77697 2.INSTALL NO. 1 FUEL TANK HEAT INSULATOR
77213E 3.INSTALL FUEL TANK TO FILLER PIPE HOSE
Install the fuel tank to filler pipe hose to the fuel tank sub-assembly, and tighten the clamp to secure the hose as shown in the illustration.
77259C 4.INSTALL FUEL HOSE
77642A 5.INSTALL NO. 2 FUEL TANK PROTECTOR
77209C 6.INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
77001A 7.INSTALL FUEL TANK SUB-ASSEMBLY
|
|
Set the fuel tank sub-assembly on an engine lifter and raise the fuel tank sub-assembly.
Install the 2 fuel tank bands with the 2 pins and 2 clips.
Install the 2 fuel tank bands with the 2 bolts.
77209C 8.CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Connect the fuel tank main tube sub-assembly.
Click hereEngine / Hybrid System>F33A-FTV (FUEL)>FUEL SYSTEM>PRECAUTION
77259C 9.CONNECT FUEL HOSE
77213E 10.CONNECT FUEL TANK TO FILLER PIPE HOSE
Connect the fuel tank to filler pipe hose to the fuel tank filler pipe, and tighten the clamp to secure the hose as shown in the illustration.
11.CONNECT NO. 1 FUEL TANK BREATHER TUBE SUB-ASSEMBLY
Connect the No. 1 fuel tank breather tube sub-assembly to the fuel tank filler pipe.
Click hereEngine / Hybrid System>F33A-FTV (FUEL)>FUEL SYSTEM>PRECAUTION
77607C 12.INSTALL NO. 2 FUEL TANK PROTECTOR SUB-ASSEMBLY
77010 13.INSTALL FUEL TANK VENT TUBE ASSEMBLY
77310A 14.INSTALL FUEL TANK CAP ASSEMBLY
37110F 15.INSTALL REAR PROPELLER SHAFT ASSEMBLY
17420 16.INSTALL CENTER EXHAUST PIPE ASSEMBLY
17.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
18.BLEED AIR FROM FUEL SYSTEM
19. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
20.INSPECT FOR FUEL LEAK
21.INSPECT FOR EXHAUST GAS LEAK