Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (w/o Emergency Call Service) › from 2022.11
RM38G0E _56 Audio / Visual / Telematics _100608 TELEMATICS _0562784 TELEMATICS SYSTEM(w/o Emergency Call Service) C

TELEMATICS  TELEMATICS SYSTEM(w/o Emergency Call Service)  B15C111  GNSS Antenna Circuit Short to Ground  B15C113  GNSS Antenna Circuit Open  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the roof antenna assembly circuit.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B15C111 GNSS Antenna Circuit Short to Ground Current to the roof antenna assembly is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON
(Short circuit)
·

Telephone transceiver assembly

·

Roof antenna assembly

·

No. 3 antenna cord sub-assembly

·

Antenna cord sub-assembly


Telematics A
B15C113 GNSS Antenna Circuit Open Current to the roof antenna assembly is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON
(Open circuit)
·

Telephone transceiver assembly

·

Roof antenna assembly

·

No. 3 antenna cord sub-assembly

·

Antenna cord sub-assembly


Telematics A

WIRING DIAGRAM

E464138E03
2.313,0.385 2.469,0.583 0.156,0.198 10 false A 2.313,0.969 2.469,1.167 0.156,0.198 10 false A 3.885,0.385 4.042,0.583 0.156,0.198 10 false B 3.885,0.969 4.042,1.167 0.156,0.198 10 false B 5.458,0.979 5.615,1.177 0.156,0.198 10 false C 5.458,0.385 5.615,0.583 0.156,0.198 10 false C 2.323,0.167 2.479,0.365 0.156,0.198 10 false 2 3.896,0.156 4.052,0.354 0.156,0.198 10 false 2 5.458,0.167 5.615,0.365 0.156,0.198 10 false 1 5.427,0.76 5.656,0.99 0.229,0.229 10 false 1a 3.854,0.75 4.083,0.979 0.229,0.229 10 false 2a 2.281,0.75 2.51,0.979 0.229,0.229 10 false 2a 5.76,0.375 6.354,0.573 0.594,0.198 10 false ANT2 5.625,2 7.021,2.427 1.396,0.427 10 false Telephone Transceiver Assembly 4.24,2.01 5.177,2.458 0.938,0.448 10 false Antenna Cord Sub-assembly 2.563,2.01 3.792,2.458 1.229,0.448 10 false No. 3 Antenna Cord Sub-assembly 0.833,2.031 2.396,2.469 1.563,0.438 10 false Roof Antenna Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (w/o Emergency Call Service)>PRECAUTION

·

When replacing the telephone transceiver assembly, make sure to replace it with a new one.



PROCEDURE

1.CLEAR DTC

Pre-procedure1

a.

Turn the ignition switch to ON and wait for 10 seconds or more.


Procedure1

b.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 459
Result:
Proceed to
NEXT



Post-procedure1

c.

None



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Telematics > Trouble Codes
50001 459

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

B

3.INSPECT NO. 3 ANTENNA CORD SUB-ASSEMBLY
3.INSPECT NO. 3 ANTENNA CORD SUB-ASSEMBLY

Pre-procedure1

a.
E462683C01
0.271,1.031 0.583,1.344 0.313,0.313 0.521,3.542 0.823,3.813 0.302,0.271 1.594,0.969 1.417,0.667 1.417,0.667 1.25,0.667 true 1.708,3.875 2.063,4.313 2.063,4.313 2.219,4.313 true 0.26,0.219 0.573,0.417 0.313,0.198 10 false *a 0.292,1.969 0.604,2.167 0.313,0.198 10 false *b 0.354,1.104 0.667,1.302 0.313,0.198 10 false A 0.625,3.615 0.938,3.813 0.313,0.198 10 false B 1.021,0.552 1.333,0.75 0.313,0.198 10 false 2a 2.281,4.219 2.594,4.417 0.313,0.198 10 false 2a
*a Front view of wire harness connector
(to Roof Antenna Assembly)
*b Front view of wire harness connector
(to Antenna Cord Sub-assembly)


Disconnect the antenna connector from the roof antenna assembly connector.


b.

Disconnect the antenna connector from the antenna cord sub-assembly connector.


Procedure1

c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-2 - B-2 Always Below 1 Ω
A-2a - B-2a Always Below 1 Ω
A-2 - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

d.

None.



OK

4.INSPECT ANTENNA CORD SUB-ASSEMBLY

NG

4.INSPECT ANTENNA CORD SUB-ASSEMBLY

Pre-procedure1

a.
E462684C01
1.542,0.156 1.854,0.469 0.313,0.313 0.906,2.219 1.208,2.49 0.302,0.271 1.76,1.26 2.25,1.552 2.25,1.552 2.406,1.552 true 1.75,2.552 2.198,2.188 2.198,2.188 2.354,2.188 true 1.844,2.688 2.24,2.917 2.24,2.917 2.396,2.917 true 0.26,0.219 0.573,0.417 0.313,0.198 10 false *a 0.292,1.969 0.604,2.167 0.313,0.198 10 false *b 1.656,0.229 1.969,0.427 0.313,0.198 10 false B 1.01,2.292 1.323,2.49 0.313,0.198 10 false C 2.479,1.469 2.792,1.667 0.313,0.198 10 false 2a 2.49,2.823 2.802,3.021 0.313,0.198 10 false 1a 2.438,2.104 2.875,2.333 0.438,0.229 10 false ANT2
*a Front view of wire harness connector
(to No. 3 Antenna Cord Sub-assembly)
*b Front view of wire harness connector
(to Telephone Transceiver Assembly)


Disconnect the antenna connector from the No. 3 antenna cord sub-assembly connector.


b.

Disconnect the antenna connector from the telephone transceiver assembly connector.


Procedure1

c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
B-2 - C-1 (ANT2) Always Below 1 Ω
B-2a - C-1a Always Below 1 Ω
B-3 - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

d.

None.



OK

5.REPLACE ROOF ANTENNA ASSEMBLY

NG

5.REPLACE ROOF ANTENNA ASSEMBLY

Pre-procedure1

a.

Replace the roof antenna assembly with a new or known good one.

HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEPHONE ANTENNA>REMOVAL



Procedure1

b.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 459
Result:
Proceed to
NEXT



Post-procedure1

c.

None



NEXT

6.CHECK FOR DTC
6.CHECK FOR DTC
a.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 459

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

END (ROOF ANTENNA ASSEMBLY IS DEFECTIVE)

B

7.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
7.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
a.

Replace the telephone transceiver assembly with a new one.

HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL



Result:
Proceed to
NEXT



NEXT