Home › Engine / Hybrid System › 1VD-FTV (FUEL) › FUEL SUPPLY PUMP (w/o DPF) › 2014.08–2022.09
RM25T0E _51 Engine / Hybrid System _029770 1VD-FTV FUEL _0135396 FUEL SUPPLY PUMP(w/o DPF) A

1VD-FTV FUEL  FUEL SUPPLY PUMP(w/o DPF)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, watching time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17940D 4.REMOVE INTERCOOLER ASSEMBLY

Hide 23705 8.REMOVE NO. 5 INJECTION PIPE SUB-ASSEMBLY

NOTICE:

After removing the fuel pipe, to prevent dirt or foreign objects from entering the pipe inlet, cover the common rail with electrical tape. Also protect the injector inlets with electrical tape or plastic bags.


a.
A165135

Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 5 injection pipe sub-assembly from the fuel supply pump assembly.


Hide 11324 9.REMOVE TIMING CHAIN COVER PLATE

A164268

a.

Remove the 4 bolts, timing chain cover plate and gasket.


Hide 23811G 10.REMOVE NO. 1 FUEL PIPE

A271425

a.

Remove the union bolt, No. 1 fuel pipe and 2 gaskets from the fuel supply pump assembly.


Hide 22100 11.REMOVE FUEL SUPPLY PUMP ASSEMBLY

a.
A271426

Disconnect the fuel temperature sensor connector.


b.
A164270N01
0.813,2.563 0.813,2.948 true 0.688,2.979 1.031,3.188 0.344,0.208 10 true SST

Using SST, fix the crankshaft pulley in place. Then remove the set nut.

SST
09960-10010  (09962-01000, 09963-01000)


c.
A271419

Loosen the 2 nuts.


d.

Using a 6 mm hexagon wrench, loosen the bolt.


e.
A164267N01
1.75,1.01 2.25,0.438 true 2.313,0.344 2.677,0.531 0.365,0.188 10 true SST

Using SST, disconnect the fuel supply pump assembly from the injection pump drive gear.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05031)

NOTICE:

Apply lubricant to the threads and tip of SST (center bolt) before using it.



f.

Remove the 2 nuts.


g.

Using a 6 mm hexagon wrench, remove the bolt. Then remove the fuel supply pump assembly.

NOTICE:
·

Do not hold or carry the fuel supply pump assembly by holding the pipe.

·

The fuel supply pump assembly must be kept horizontal.




h.

Remove the O-ring.