Home › Drivetrain › HF1A (TRANSFER / 4WD / AWD) › TRANSFER SHIFT LEVER ASSEMBLY › 2014.08–2016.08
RM25T0E _52 Drivetrain _029904 HF1A TRANSFER / 4WD / AWD _0138374 TRANSFER SHIFT LEVER ASSEMBLY A

HF1A TRANSFER / 4WD / AWD  TRANSFER SHIFT LEVER ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 67913 4.REMOVE FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure described for the LH side.


Hide 62112A 5.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

Hide 62111A 6.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 89170 10.REMOVE AIRBAG SENSOR ASSEMBLY WITH AIRBAG SENSOR BRACKET (w/ Airbag System)

Hide 89441A 11.REMOVE DECELERATION SENSOR (w/ ABS)

Hide 36303 12.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

a.
C311944C01
2.635,0.938 2.448,0.938 2.448,0.938 2.229,0.49 true 0.344,0.729 1.333,0.729 1.333,0.729 1.635,0.927 true 0.146,0.646 0.458,0.844 0.313,0.198 10 true *1 2.677,0.854 3.313,1.26 0.635,0.406 10 true *2
*1 Shift Lever Knob Sub-assembly (for Transfer Side)
*2 Shift Lever Knob Sub-assembly (for Transmission Side)


Twist the 2 shift lever knob sub-assembly in the direction indicated by the arrow and remove it.


Hide 58286 13.REMOVE NO. 1 SHIFT AND SELECT LEVER BOOT

a.
C213901

Fold back the floor carpet until it is possible to remove the No. 1 shift and select lever boot.

HINT:

Remove the front seat assembly if necessary.




b.

Remove the 6 bolts and No. 1 shift and select lever boot.


Hide 14.REMOVE TRANSFER SHIFT LEVER ASSEMBLY

HINT:

Put the transfer shift lever assembly in the L4 position before performing work.


a.
C311918

Remove the 3 bolts and disconnect the transfer shift lever assembly.


b.
C311895

Remove the 4 bolts, transfer control shift lever retainer bracket and transfer control shift lever retainer gasket.


c.

Remove the nut and washer and then disconnect the high and low shift rod sub-assembly.


d.

Remove the transfer shift lever assembly.

HINT:

Lower the transfer shift lever assembly towards the bottom of the vehicle to remove it.



Hide 36331 15.REMOVE TRANSFER SHIFT LEVER BOOT

a.
C311886

Remove the transfer shift lever boot from the transfer shift lever assembly.


Hide 36327 16.REMOVE TRANSFER SHIFT LEVER SHAFT

a.
C311887

Using a snap ring expander, remove the front transfer drive shift lever hole snap ring from the transfer shift lever assembly.


b.

Remove the plate washer and transfer shift lever compression spring from the transfer shift lever assembly.


c.
C311888

Remove the slotted pin, transfer shift lever shaft and transfer shift lever bush from the transfer shift lever assembly.


d.
C311889C01
1.979,1.583 2.219,1.583 2.219,1.583 2.219,1.104 true 1.813,1.302 2.052,1.302 2.052,1.302 2.052,1.021 true 1.75,1.5 2.063,1.698 0.313,0.198 10 false *1 1.625,1.208 1.938,1.406 0.313,0.198 10 false *2
*1 Wave Washer
*2 Transfer Shift Lever Bush


Remove the wave washer and transfer shift lever bush from the transfer shift lever shaft.


Hide 36360G 17.REMOVE TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY

a.

Remove the transfer high and low shift lever assembly from the transfer shift lever assembly.


b.

Remove the transfer shift lever support from the transfer shift lever assembly.


Hide 33554B 18.REMOVE TRANSFER SHIFT LEVER CAP

a.
C311890C01
0.823,0.604 1.01,0.604 1.01,0.604 1.219,0.948 false 0.604,0.542 0.917,0.74 0.313,0.198 10 false *1
*1 Straight Pin


Remove the 3 bolts and transfer shift lever cap from the transfer control shift lever retainer.


b.

Remove the straight pin from the transfer control shift lever retainer.


Hide 36331A 19.REMOVE NO. 2 TRANSFER SHIFT LEVER BOOT

a.

Remove the No. 2 transfer shift lever boot from the transfer high and low shift lever assembly.