1.INSPECT BRAKE PEDAL AND PARKING BRAKE
2.INSPECT BRAKE LININGS AND DRUMS
3.INSPECT BRAKE PADS AND DISCS
Inspect the brake pads and discs.
| Type | See procedure |
|---|---|
| Front brake | ( ) |
| Rear brake (for Rear Disk Brake) | ( ) |
If a squealing or scraping noise is heard from the brake while driving, check the pad wear indicator.
If there are traces of the indicator contacting the disc rotor, the disc pad should be replaced.
4.INSPECT BRAKE LINE PIPES AND HOSES
Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.
Using a mirror, check the entire circumference and length of the brake lines and hoses for:
Damage
Wear
Deformation
Cracks
Corrosion
Leaks
Bends
Twists
Check all the clamps for tightness and the connections for leakage.
Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system.
Check that the lines are installed properly and pass through the center of the grommets.
9.INSPECT CLUTCH FLUID
Inspect the clutch fluid (See page Drivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING).