Home › Drivetrain › H150F (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSMISSION ASSEMBLY (for 1VD-FTV) › from 2022.09
RM25T0E _52 Drivetrain _029902 H150F MANUAL TRANSMISSION / TRANSAXLE _0137561 MANUAL TRANSMISSION ASSEMBLY(for 1VD-FTV) A

H150F MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSMISSION ASSEMBLY(for 1VD-FTV)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 51442 3.REMOVE NO. 2 ENGINE UNDER COVER

Hide 16571C 5.REMOVE NO. 1 RADIATOR HOSE

Hide 17881 6.REMOVE NO. 1 AIR CLEANER HOSE

Hide 8.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 17805 9.REMOVE INTAKE AIR CONNECTOR SUB-ASSEMBLY

Hide 17875 10.REMOVE INTAKE AIR CONNECTOR PIPE

Hide 16470 11.REMOVE RADIATOR RESERVOIR ASSEMBLY

Hide 16711 12.REMOVE FAN SHROUD

Hide 16371 13.REMOVE FAN PULLEY

Hide 87240 14.REMOVE HEATER WATER VALVE ASSEMBLY

C162224

a.

Disconnect the cable from the heater water valve assembly.


b.
C162223

Slide the 2 clamps and disconnect the 2 hoses from the heater water valve assembly.


c.

Remove the bolt and heater water valve assembly from the vehicle.


Hide 67913 16.REMOVE FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure described for the LH side.


Hide 62111A 18.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 89170 22.REMOVE AIRBAG SENSOR ASSEMBLY WITH AIRBAG SENSOR BRACKET (w/ Airbag System)

Hide 89441A 23.REMOVE DECELERATION SENSOR (w/ ABS)

Hide 36303 24.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 58286 25.REMOVE NO. 1 SHIFT AND SELECT LEVER BOOT

Hide 33530F 26.REMOVE TRANSMISSION SHIFT LEVER ASSEMBLY

C313778C01
1.333,0.635 1.5,0.219 1.5,0.219 1.75,0.219 true 1.875,0.135 2.188,0.333 0.313,0.198 10 false *a
*a Cloth or Equivalent
V100135

Down
V100136

Counterclockwise


a.

Cover the transmission shift lever cap with a cloth or equivalent.


b.

While pressing down on the transmission shift lever cap, turn it counterclockwise to remove the transmission shift lever.


c.

Pull out the transmission shift lever assembly.


Hide 27.REMOVE TRANSFER SHIFT LEVER ASSEMBLY

Hide 36308 28.DISCONNECT HIGH AND LOW SHIFT ROD SUB-ASSEMBLY

a.

Remove the nut and washer, disconnect the high and low shift rod sub-assembly.


Hide 12140 30.REMOVE OIL PAN COVER

C163585

a.

Remove the 2 bolts and oil pan cover.


Hide 51447C 31.REMOVE TRANSFER CASE PROTECTOR

C161524

a.

Remove the 3 bolts and transfer case protector from the No. 2 frame crossmember sub-assembly.


Hide 37140 32.REMOVE FRONT PROPELLER SHAFT ASSEMBLY

Hide 37110 33.REMOVE REAR PROPELLER SHAFT ASSEMBLY

Hide 31470 36.REMOVE CLUTCH RELEASE CYLINDER ASSEMBLY

C160837

a.

Remove the 2 bolts and clutch release cylinder assembly.


Hide 37.REMOVE FRONT STABILIZER BRACKET LH

C161532

a.

Remove the 2 bolts and front stabilizer bracket LH.


Hide 38.REMOVE FRONT STABILIZER BRACKET RH

HINT:

Use the same procedure described for the LH side.


Hide 39.SUPPORT MANUAL TRANSMISSION WITH TRANSFER

C160886

a.

Support the manual transmission with a transmission jack.


Hide 51203 40.REMOVE NO. 2 FRAME CROSSMEMBER SUB-ASSEMBLY

C160838

a.

Remove the 8 bolts.


b.

Remove the 2 nuts and No. 2 frame crossmember sub-assembly.


Hide 12371 41.REMOVE REAR ENGINE MOUNTING INSULATOR

C161536

a.

Remove the 4 bolts and rear engine mounting insulator from the manual transmission with transfer.


Hide 42.DISCONNECT WIRE HARNESS

a.
C312643

Remove the bolt and disconnect the ground cable.


b.
C312650

Remove the wire harness clamp and disconnect the wire harness from the manual transmission.


c.

Tilt down the manual transmission.


d.
C312358

Support the engine assembly with the jack and engine lifter so that it is stable as shown in the illustration.


e.

Disconnect the connectors and clamps, and then disconnect the wire harness from the manual transmission assembly.


Hide 43.REMOVE MANUAL TRANSMISSION WITH TRANSFER

C160844

a.

Remove the 10 bolts.


b.

Separate and remove the manual transmission with transfer.

NOTICE:

Do not use excess force to pry off the transmission assembly.



Hide 44.REMOVE TRANSFER ASSEMBLY

C161482

a.

Remove the 6 bolts and transfer assembly from the manual transmission.


Hide 45.REMOVE WIRE HARNESS CLAMP BRACKET

C313767

a.

Remove the 4 bolts and 4 wire harness clamp brackets.


Hide 31204 46.REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY

Hide 31237 47.REMOVE CLUTCH RELEASE FORK SUPPORT BOOT

Hide 31236B 48.REMOVE RELEASE FORK SUPPORT