| *1 | TRANSAXLE OIL PUMP DRIVE ROTOR | *2 | TRANSMISSION OIL PUMP DRIVEN ROTOR |
| *3 | TRANSMISSION OIL PUMP COVER PLUG | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
|
Toyota Genuine ATF WS | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 8 | REAR SUSPENSION BRACE COVER | 53661B | - | - | - |
| 9 | NO. 2 DIFFERENTIAL SUPPORT PROTECTOR | 52384C | - | - | - |
| 10 | NO. 1 DIFFERENTIAL SUPPORT PROTECTOR | 52383E | - | - | - |
35308D
1.INSTALL TRANSMISSION OIL PUMP COVER SUB-ASSEMBLY
| *1 | Transaxle Oil Pump Drive Rotor | *2 | Transmission Oil Pump Driven Rotor |
| *a | Matchmark | - | - |
Install a new O-ring to the FCV with motor transaxle assembly.
Be careful not to damage the O-ring.
Apply ATF to the transaxle oil pump drive rotor and transmission oil pump driven rotor.
Install the transaxle oil pump drive rotor and transmission oil pump driven rotor to the FCV with motor transaxle assembly.
Align the matchmarks on the transaxle oil pump drive rotor and the transmission oil pump driven rotor.
If the transaxle oil pump drive rotor or transmission oil pump driven rotor has been replaced, inspect the transaxle fluid pressure.
Coat a new O-ring with ATF and install it to the transmission oil pump cover plug.
Install the transmission oil pump cover plug to the transmission oil pump cover sub-assembly.
Install the transmission oil pump cover sub-assembly to the FCV with motor transaxle assembly with the 4 bolts.
Make sure that the O-ring is not cut or pinched during installation.
32904B
2.CONNECT OIL COOLER INLET TUBE SUB-ASSEMBLY
| *a | Oil Cooler Inlet Tube Sub-assembly Stopper | *b | Transmission Oil Pump Cover Sub-assembly Hole |
Connect the oil cooler inlet tube sub-assembly to the FCV with motor transaxle assembly with the bolt as shown in the illustration.
Insert the oil cooler inlet tube sub-assembly stopper into the transmission oil pump cover sub-assembly hole.
53661B
8.INSTALL REAR SUSPENSION BRACE COVER
52384C
9.INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR
52383E
10.INSTALL NO. 1 DIFFERENTIAL SUPPORT PROTECTOR