|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 6 | REAR SUSPENSION BRACE COVER | 53661B | - | - | - |
| 7 | NO. 2 DIFFERENTIAL SUPPORT PROTECTOR | 52384C | - | - | - |
| 8 | NO. 1 DIFFERENTIAL SUPPORT PROTECTOR | 52383E | - | - | - |
35300
1.INSTALL OIL WITH MOTOR PUMP ASSEMBLY
|
Fluid is not attached | - | - |
Install the 2 transmission oil pump O-rings to the FCV with motor transaxle assembly.
Ensure that the O-rings are not twisted or damaged.
Before installing the transmission oil pump O-ring, make sure that fluid is not attached to the O-ring groove and the mating surface of the oil with motor pump assembly.
|
Bolt A |
|
Bolt B |
|
Bolt C |
|
Connector |
Install the 3 bolts and oil with motor pump assembly to the FCV with motor transaxle assembly.
Tightening order: Temporarily install bolt A → Temporarily install bolt B → Temporarily install bolt C → Tighten bolt A → Tighten bolt B → Tighten bolt C
Connect the oil with motor pump assembly connector.
53661B
6.INSTALL REAR SUSPENSION BRACE COVER
52384C
7.INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR
52383E
8.INSTALL NO. 1 DIFFERENTIAL SUPPORT PROTECTOR