Home › Drivetrain › Q710 (HYBRID TRANSMISSION / TRANSAXLE) › SHIFT CONTROL ACTUATOR
RM37H0E _52 Drivetrain _093826 Q710 HYBRID TRANSMISSION / TRANSAXLE _0442248 SHIFT CONTROL ACTUATOR A

Q710 HYBRID TRANSMISSION / TRANSAXLE  SHIFT CONTROL ACTUATOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C442800N03
2.417,0.75 2.938,0.75 false 6.063,2 6.583,2 false 5.083,1.083 5.5,0.667 5.5,0.667 5.75,0.667 false 1.083,1.75 1.333,1.75 1.333,1.75 1.667,2.25 false 2.208,0.625 2.458,0.875 0.25,0.25 18 false 2 6.625,1.875 6.875,2.125 0.25,0.25 18 false 3 5.792,0.542 6.042,0.792 0.25,0.25 18 false 4 0.875,1.625 1.125,1.875 0.25,0.25 18 false 1 3.188,1.313 3.521,1.479 0.333,0.167 10 false x 2 5.604,1.625 5.938,1.792 0.333,0.167 10 false x 4 4.99,2.063 5.323,2.229 0.333,0.167 10 false x 2 5.375,2.656 5.708,2.823 0.333,0.167 10 false x 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 REAR FLOOR SIDE MEMBER COVER LH 57628E - - -
2 NO. 1 DIFFERENTIAL SUPPORT PROTECTOR 52383E - - -
3 NO. 2 DIFFERENTIAL SUPPORT PROTECTOR 52384C - - -
4 REAR SUSPENSION BRACE COVER 53661B - - -

C442801N03
3.25,1.917 3.25,1.542 3.25,1.542 3.469,1.542 false 4.396,2.323 4.583,2.583 4.583,2.583 4.75,2.583 false 1.417,1.917 1.667,1.917 1.667,1.917 2.063,2.375 false 6.771,0.188 6.271,0.188 false 1.083,2.75 1.833,2.75 false 2.531,3 3.083,3 false 6.063,0.063 6.313,0.396 0.25,0.333 18 false 5 3.833,1.417 4.083,1.75 0.25,0.333 18 false 6 5.354,2.469 5.604,2.802 0.25,0.333 18 false 7 3.135,2.875 3.385,3.208 0.25,0.333 18 false 8 1.229,1.781 1.479,2.115 0.25,0.333 18 false 9 2.677,2.469 3.01,2.635 0.333,0.167 10 false x 2 0.875,2.667 1.083,2.833 0.208,0.167 10 false *1 5.177,2.542 5.344,2.708 0.167,0.167 10 false ●

Procedure Part Name Code
Z101186

Z101188

Z101187

5 DRAIN HYBRID TRANSAXLE FLUID - - (Click here) -
6 SHIFT CONTROL ACTUATOR ASSEMBLY 35580 (Click here) - -
7 SHIFT CONTROL ACTUATOR SEAL 35563 (Click here) - -
8 TRANSMISSION CONTROL SHAFT LEVER - - - -
9 NO. 1 PARKING LOCK RELEASE CABLE CLAMP BRACKET - - - -

*1 SPRING - -
● Non-reusable part - -

PROCEDURE

Hide 57628E 1.REMOVE REAR FLOOR SIDE MEMBER COVER LH

Hide 52383E 2.REMOVE NO. 1 DIFFERENTIAL SUPPORT PROTECTOR

Hide 52384C 3.REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR

Hide 53661B 4.REMOVE REAR SUSPENSION BRACE COVER

Hide 5.DRAIN HYBRID TRANSAXLE FLUID

Z101186

Click here(Click here)

Hide 35580 6.REMOVE SHIFT CONTROL ACTUATOR ASSEMBLY

Z101186

NOTICE:

If the shift control actuator assembly is removed, replace the shift control actuator seal.



a.
C442803C03
0.042,0.042 0.875,0.375 0.833,0.333 18 false i, ii 3.542,0.042 4.375,0.375 0.833,0.333 18 false iii
V100135

Connector
V100136

Bolt
V100137

Cover - -


i.

Disconnect the connector.


ii.

Remove the 3 bolts and shift control actuator assembly from the FCV with motor transaxle assembly.

HINT:

As the position of the shift control actuator assembly is detected automatically, initialization is not necessary after disconnecting and reconnecting the cable to the negative (-) auxiliary battery terminal.



iii.

Cover the disconnected connector and connector portion of the shift control actuator assembly with a plastic bag, etc. so that coolant or foreign matter does not enter it.



Hide 35563 7.REMOVE SHIFT CONTROL ACTUATOR SEAL

a.
Z101186

NOTICE:
·

Be careful not to damage the FCV with motor transaxle assembly.

·

If the shift control actuator assembly is removed, replace the shift control actuator seal.




C442804N01
2,0.083 2.25,0.417 0.25,0.333 18 false i

i.

Using a screwdriver with its tip wrapped with protective tape, remove the shift control actuator seal from the FCV with motor transaxle assembly.



Hide 8.REMOVE TRANSMISSION CONTROL SHAFT LEVER

a.
C442806


Hide 9.REMOVE NO. 1 PARKING LOCK RELEASE CABLE CLAMP BRACKET

a.
C442807