Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › POP UP HOOD LIFTER
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0448374 POP UP HOOD LIFTER A

SUPPLEMENTAL RESTRAINT SYSTEMS  POP UP HOOD LIFTER  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B593214N02
6.427,0.188 6.885,0.188 false 6.417,0.5 6.875,0.5 false 5.063,2.604 5.75,2.604 false 0.854,1.406 1.417,1.406 false 4.146,1.125 4.708,1.125 false 5.271,1.385 5.76,1.385 false 4.135,2.198 4.594,2.198 false 6.167,0.021 6.448,0.375 0.281,0.354 18 false 1 0.646,1.271 0.927,1.625 0.281,0.354 18 false 3 6.188,0.365 6.469,0.719 0.281,0.354 18 false 2 6,2.448 6.281,2.802 0.281,0.354 18 false 4 5.99,1.25 6.271,1.604 0.281,0.354 18 false 5 4.844,1.042 5.156,1.24 0.313,0.198 10 false x 2 3.24,0.635 3.552,0.833 0.313,0.198 10 false x 6 3.677,2.271 3.99,2.469 0.313,0.198 10 false x 2 3.99,1.063 4.302,1.26 0.313,0.198 10 false ● 4.625,2.104 4.938,2.302 0.313,0.198 10 false *1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - (Click here) - -
3 UPPER RADIATOR SUPPORT SEAL 53292A - - -
4 FRONT FENDER UPPER PROTECTOR LH 53826A (Click here) - -
5 POP UP HOOD LIFTER ASSEMBLY LH 53470 (Click here) - -

*1 CENTER HOOD CUSHION - -
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the pop up hood lifter assembly removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic View Monitor System (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL

Hide 53292A 3.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 53826A 4.REMOVE FRONT FENDER UPPER PROTECTOR LH

Z101186

(Click here)

Hide 53470 5.REMOVE POP UP HOOD LIFTER ASSEMBLY LH

Z101186

CAUTION:
·
B471801

When storing the pop up hood lifter assembly LH, keep the pop up hood lifter assembly LH extended section side facing upward.

·

If the pop up hood lifter assembly LH deploys for any reason, it may cause a serious accident.




a.
B605562C01
1.042,0.458 1.833,0.458 true 0.458,0.104 0.74,0.458 0.281,0.354 18 false i 4.49,0.156 4.771,0.51 0.281,0.354 18 false ii 0.813,0.375 1.042,0.604 0.229,0.229 10 true *a
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B593216N02
4.646,1.188 4.927,1.479 0.281,0.292 18 true iii 1.135,0.625 1.292,0.938 0.156,0.313 18 true i 2.031,1.25 2.229,1.563 0.198,0.313 18 true ii 4.302,0.51 4.542,0.771 0.24,0.26 18 true iii 5.438,0.083 5.698,0.385 0.26,0.302 18 true iv 3.99,0.031 4.26,0.313 0.271,0.281 18 true iv

i.

Detach the wire harness clamp.


ii.

Disconnect airbag connector.

NOTICE:

When disconnecting any pop up hood lifter connector, take care not to damage the wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



iii.

Detach the wire harness clamp.


iv.

Remove the 2 nuts and remove the pop up hood lifter assembly LH.