| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| B2456 | Left Headlight ECU Variation Error | Detection condition:
Ignition switch ON Malfunction status:
Vehicle specification information received via CAN communication is continuously mismatched Malfunction duration:
- |
·
EV control ECU ·
Main body ECU (multiplex network body ECU) ·
Headlight ECU sub-assembly LH |
AFS | A | w/ Adaptive High Beam System |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| B2456 | Left Headlight ECU Variation Error | Detection condition:
Ignition switch ON Malfunction status:
Vehicle specification information received via CAN communication is continuously mismatched Malfunction duration:
- |
·
EV control ECU ·
Main body ECU (multiplex network body ECU) ·
Headlight ECU sub-assembly LH |
HL AutoLeveling | A | w/o Adaptive High Beam System |
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>REGISTRATION
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Check vehicle condition.
| Result | Proceed to |
|---|---|
| w/ Adaptive High Beam System | A |
| w/o Adaptive High Beam System | B |
A
B
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Turn the ignition switch to ON
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| B2456 is not output | A |
| B2456 is output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Check if the part number of the EV control ECU installed to the vehicle is correct.
Part number is correct.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check if the part number of the main body ECU (multiplex network body ECU) installed to the vehicle is correct.
Part number is correct.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Turn the ignition switch to ON
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| B2456 is not output | A |
| B2456 is output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B