The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof or removable roof housing sub-assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
62180A
3.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
62170A
4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH
Use the same procedure described for the LH side.
5.REMOVE SLIDING ROOF HOUSING FRONT BRACKET RH
6.REMOVE SLIDING ROOF HOUSING FRONT BRACKET LH
Use the same procedure described for the RH side.
7.REMOVE SLIDING ROOF HOUSING REAR BRACKET RH
8.REMOVE SLIDING ROOF HOUSING REAR BRACKET LH
Use the same procedure described for the RH side.
63203A
9.REMOVE SLIDING ROOF OR REMOVABLE ROOF HOUSING SUB-ASSEMBLY
|
|