Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM
RM37H0E _59 Vehicle Exterior _095212 WIPER / WASHER _0447384 WIPER AND WASHER SYSTEM Y

WIPER / WASHER  WIPER AND WASHER SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the wiper and washer system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
Result:
Proceed to
NEXT



NEXT

3.READ AND SAVE OPERATION HISTORY
3.READ AND SAVE OPERATION HISTORY
NOTICE:
·

If the vehicle or vehicle controls are operated (for example, during initial inspection when the vehicle is brought in for repair) before operation history has been read out and saved, the operation history information could be lost.

·

The function "Read operation history" uses the current system time setting inside the GTS and the time counter inside the controlling ECU to calculate the timings shown in the operation history. For this reason, before reading out the operation history, first make sure that the GTS system clock is accurately set to the current time.



a.

Read and save operation history using the GTS.

Click hereVehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM>CHECK FOR INTERMITTENT PROBLEMS

Body Electrical > Wiper > Utility
Tester Display
Operation History
50005 384 52

Result:
Proceed to
NEXT



NEXT

4.INSPECT AUXILIARY BATTERY VOLTAGE
4.INSPECT AUXILIARY BATTERY VOLTAGE
a.

Measure the auxiliary battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.


Result:
Proceed to
NEXT



NEXT

5.CHECK CAN COMMUNICATION SYSTEM*
5.CHECK CAN COMMUNICATION SYSTEM*

Result:
Result Proceed to
CAN communication DTCs are not output. A
CAN communication DTCs are output. B



A

6.CHECK FOR DTC*

B

6.CHECK FOR DTC*
a.

Check for DTCs.

Body Electrical > Wiper > Trouble Codes
50001 384
Body Electrical > Main Body > Trouble Codes
50001 123
Body Electrical > Rain and/or Humidity Sensor > Trouble Codes
50001 199

Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

7.PROBLEM SYMPTOMS TABLE

B

7.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table (Fault can be simulated) A
Fault is not listed in Problem Symptoms Table (Fault cannot be simulated) B
Fault is listed in Problem Symptoms Table C



A

8.OVERALL ANALYSIS AND TROUBLESHOOTING

B

C

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

8.OVERALL ANALYSIS AND TROUBLESHOOTING



d.

Inspection


e.

On-vehicle inspection


Result:
Proceed to
NEXT



NEXT

9.ADJUST, REPAIR OR REPLACE
9.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

10.CONFIRMATION TEST
10.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END