Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM37H0E _58 Vehicle Interior _095316 METER / GAUGE / DISPLAY _0455143 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Steering Pad Switch Circuit  


DESCRIPTION

The combination meter assembly and steering pad switch assembly are connected via direct line. The main display and multi-information display in the combination meter assembly are operated using the switches of the steering pad switch assembly.

WIRING DIAGRAM

E462762E01
0.906,1.646 1.521,1.844 0.615,0.198 10 false Left 0.948,2.156 1.563,2.354 0.615,0.198 10 false Up 0.906,2.656 1.521,2.854 0.615,0.198 10 false Down 0.875,3.146 1.49,3.344 0.615,0.198 10 false Right 2.438,2.625 3.052,2.823 0.615,0.198 10 false Enter 2.427,3.156 3.042,3.354 0.615,0.198 10 false Back 3.531,0.792 3.781,0.99 0.25,0.198 10 false 5 3.521,1.781 3.771,1.979 0.25,0.198 10 false 4 3.479,3.281 3.729,3.479 0.25,0.198 10 false 12 3.49,0.958 3.708,1.156 0.219,0.198 10 false Z5 3.479,1.969 3.656,2.156 0.177,0.188 10 false Z5 3.49,3.479 3.688,3.656 0.198,0.177 10 false Z5 4.479,0.792 4.729,0.99 0.25,0.198 10 false 10 4.479,1.792 4.729,1.99 0.25,0.198 10 false 11 4.521,3.302 4.771,3.5 0.25,0.198 10 false 2 5.552,0.865 5.719,1.063 0.167,0.198 10 false 3 5.573,1.875 5.729,2.083 0.156,0.208 10 false 2 4.438,0.958 4.74,1.156 0.302,0.198 10 false D32 4.438,1.958 4.75,2.146 0.313,0.188 10 false D32 4.438,3.469 4.729,3.667 0.292,0.198 10 false D32 3.885,0.885 4.406,1.073 0.521,0.188 10 false +DP2 3.906,1.885 4.427,2.073 0.521,0.188 10 false +DP 3.906,3.385 4.427,3.573 0.521,0.188 10 false ECC 5.76,2.49 6.073,2.677 0.313,0.188 10 false D41 5.802,0.865 6.188,1.073 0.385,0.208 10 false MSTI 5.781,1.865 6.26,2.073 0.479,0.208 10 false MSM+ 6.75,1.813 7.031,2.156 0.281,0.344 10 false 5V 6.74,0.833 7.021,1.177 0.281,0.344 10 false 5V 3.458,4.115 5.125,4.313 1.667,0.198 10 false Spiral Cable Sub-assembly 5.76,2.646 6.938,3.01 1.177,0.365 10 false Combination Meter Assembly 0.927,4.125 2.854,4.333 1.927,0.208 10 false Steering Pad Switch Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



PROCEDURE

1.READ VALUE USING GTS
a.

Read the Data List according to the display on the GTS.

Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Multi Switch (Up) Up switch on steering pad switch operation OFF or ON OFF: Switch released
ON: Switch pushed
-
Multi Switch (Down) Down switch on steering pad switch operation OFF or ON OFF: Switch released
ON: Switch pushed
-
Multi Switch (Left) Left switch on steering pad switch operation OFF or ON OFF: Switch released
ON: Switch pushed
-
Multi Switch (Right) Right switch on steering pad switch operation OFF or ON OFF: Switch released
ON: Switch pushed
-
Multi Switch (Enter) OK switch on steering pad switch operation OFF or ON OFF: Switch released
ON: Switch pushed
-
Multi Switch (Back) Back switch on steering pad switch operation OFF or ON OFF: Switch released
ON: Switch pushed
-
Multi Switch (Menu) Menu switch on steering pad switch operation OFF or ON OFF: Switch released
ON: Switch pushed
-
Body Electrical > Combination Meter > Data List
Tester Display
Multi Switch (Up)
Multi Switch (Down)
Multi Switch (Left)
Multi Switch (Right)
Multi Switch (Enter)
Multi Switch (Back)
Multi Switch (Menu)
50003 409 12,13,14,15,16,17,18
OK:

Multi switch condition displayed on the GTS changes with the actual switch operation.



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

2.INSPECT STEERING PAD SWITCH ASSEMBLY
2.INSPECT STEERING PAD SWITCH ASSEMBLY

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION

Result:
Proceed to
OK
NG



OK

3.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

3.INSPECT SPIRAL CABLE SUB-ASSEMBLY

OK

4.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

4.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)
a.

Disconnect the D41 combination meter assembly connector.


b.

Disconnect the D32 spiral cable sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D41,D32)Location & Routing

Click Connector(D41)Instrument Panel>Instrument Panel Wire>Combination Meter Assembly

Click Connector(D32)Instrument Panel>Instrument Panel Wire>Spiral Cable Sub-Assembly

D41-2 (MSM+) - D32-11 (+DP) Always Below 1 Ω
D41-3 (MSTI) - D32-10 (+DP2) Always Below 1 Ω
D41-2 (MSM+) - Other terminals and body ground Always 10 kΩ or higher
D41-3 (MSTI) - Other terminals and body ground Always 10 kΩ or higher
D32-2 (ECC) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR