This DTC is output when the semiconductor power integration ECU detects a load malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1000 | ECU Malfunction | Malfunction detected with semiconductor power integration ECU output/input | No. 1 semiconductor power integration ECU (w/ PTC Heater) | Power Integration No.2 | A |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1000 | ECU Malfunction | Malfunction detected with semiconductor power integration ECU output/input | No. 2 semiconductor power integration ECU | Power Integration No.3 | A |
When using the GTS with the ignition switch off to troubleshoot:
Connect the GTS to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the GTS and vehicle begins.
Inspect the fuses for circuits related to this system before performing the following procedure.
Before performing troubleshooting, check whether there are any malfunctions with the lighting system.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Before performing troubleshooting, check whether there are any malfunctions with the air conditioning system.
Before performing troubleshooting, check whether there are any malfunctions with the electronically controlled brake system.
Before performing troubleshooting, check whether there are any malfunctions with the dynamic radar cruise control system.
Before performing troubleshooting, check whether there are any malfunctions with the pre-collision system.
Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>PRE-COLLISION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Before performing troubleshooting, check whether there are any malfunctions with the electronic shift lever system.
Before performing troubleshooting, check whether there are any malfunctions with the window defogger system.
Click hereVehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
No. 1 semiconductor power integration ECU (w/ PTC Heater)
Clear the DTCs.
No. 2 semiconductor power integration ECU
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for vehicle type.
| Result | Proceed to |
|---|---|
| w/ PTC Heater | A |
| w/o PTC Heater | B |
A
B
Check for DTCs.
| Result | Proceed to |
|---|---|
| B1000 is not output | A |
| B1000 is output | B |
A
B
Check for DTCs.
| Result | Proceed to |
|---|---|
| B1000 is not output | A |
| B1000 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B