Home › Engine / Hybrid System › COOLING › COOLANT
RM37H0E _51 Engine / Hybrid System _097304 COOLING _0455465 COOLANT L

COOLING  COOLANT  PRECAUTION  


CAUTION:
·

When the coolant (Toyota genuine FC stack coolant (Pre-mixed)) is hot, do not remove the reserve tank cap, FC radiator assembly drain cock plug or the intercooler assembly side drain cock plug.

·

Fluid and steam may spray out due to high pressure, possibly resulting in burns.



NOTICE:
·

Do not turn the ignition switch to ON (READY) when there is no coolant (Toyota genuine FC stack coolant (Pre-mixed)) in the FC radiator reserve tank assembly.

·

The coolant (Toyota genuine FC stack coolant (Pre-mixed)) is an exclusive coolant.

·

The coolant (Toyota genuine FC stack coolant (Pre-mixed)) cannot be reused, so when filling, be sure to fill with new coolant (Toyota genuine FC stack coolant (Pre-mixed)).

·

Do not add liquid such as tap water or battery fluid, as it may decrease the performance of the coolant (Toyota genuine FC stack coolant (Pre-mixed)).

·

Do not use cotton work gloves or other gloves that could shed fibers.

·

DO NOT use any container that has previously been used to fill substances such as oil.

·

To prevent foreign matter from contaminating the coolant (Toyota genuine FC stack coolant (Pre-mixed)) passages, wash out the prepared container with tap water, then wipe away any water remaining inside the container before using it.

·

If liquid other than the coolant (Toyota genuine FC stack coolant (Pre-mixed)) such as water or other fluids is added, the insulation resistance in the FC stack assembly will decrease and a DTC P0AA649 (high voltage system insulation resistance abnormal) may be output for the EV control system.

·

If liquid other than the coolant (Toyota genuine FC stack coolant (Pre-mixed)) such as water or other fluids is added, it may cause a leak from the FC stack (of coolant, air, hydrogen) or reduce the life-span of the FC stack.

·

This vehicle performs FC system shutdown process after turning the ignition switch off from ON (READY). Therefore, after the ignition switch is turned off from ON (READY), do not perform any work on the electrical system for at least 10 minutes including removing connectors or disconnecting the negative (-) auxiliary battery terminal.

·

When the vehicle is parked with the ignition switch off, if the FC control ECU judges that the FC stack temperature will go below 0°C (32°F), it activates the FC air compressor, hydrogen pump and FC cooling water pump for a maximum of 180 seconds and drains water from the FC stack assembly. When performing inspection or repairs with the ignition switch off (not on (IG) or on (READY)), disconnect the cable from the negative (-) auxiliary battery terminal before performing work.



IF WRONG COOLANT HAS BEEN FILLED TO COOLANT (TOYOTA GENUINE FC STACK COOLANT (Pre-mixed)) PASSAGES


a.

If the wrong coolant has been filled to the coolant (Toyota genuine FC stack coolant (Pre-mixed)) passages, flush the system according to the following procedures.

i.

Remove the FC stack cover sub-assembly.

Click hereEngine / Hybrid System>FC CONTROL>FC STACK>REMOVAL


ii.

Remove the front compartment under cover.

Click hereEngine / Hybrid System>FC CONTROL>FC STACK>REMOVAL


iii.

Remove the front lower suspension member protector.

Click hereEngine / Hybrid System>FC CONTROL>FC STACK>REMOVAL


iv.

Remove the front compartment under cover assembly.

Click hereEngine / Hybrid System>FC CONTROL>FC STACK>REMOVAL


v.

Drain the coolant (Toyota genuine FC stack coolant (Pre-mixed)).

Click hereEngine / Hybrid System>COOLING>COOLANT>REPLACEMENT


vi.

Add coolant (Toyota genuine FC stack coolant (Pre-mixed)).

Click hereEngine / Hybrid System>COOLING>COOLANT>REPLACEMENT


vii.

With the vehicle stopped and in the P position, turn the ignition switch to On (Ready) and wait for 30 minutes or more.


viii.

Turn the ignition switch off.


ix.

Drain the coolant (Toyota genuine FC stack coolant (Pre-mixed)).

Click hereEngine / Hybrid System>COOLING>COOLANT>REPLACEMENT


x.

Add coolant (Toyota genuine FC stack coolant (Pre-mixed)).

Click hereEngine / Hybrid System>COOLING>COOLANT>REPLACEMENT


xi.

Replace the FC cooling water ion exchanger element.

Click hereGeneral>MAINTENANCE>ION EXCHANGER ELEMENT>REMOVAL


xii.

With the vehicle stopped and in the P position, turn the ignition switch on (Ready) and wait for 60 minutes or more.


xiii.

Turn the ignition switch off.


xiv.

Drain the coolant (Toyota genuine FC stack coolant (Pre-mixed)).

Click hereEngine / Hybrid System>COOLING>COOLANT>REPLACEMENT


xv.

Replace the FC cooling water ion exchanger element.

Click hereGeneral>MAINTENANCE>ION EXCHANGER ELEMENT>REMOVAL


xvi.

Add coolant (Toyota genuine FC stack coolant (Pre-mixed)).

Click hereEngine / Hybrid System>COOLING>COOLANT>REPLACEMENT


xvii.

Perform coolant leak inspection of the coolant (Toyota genuine FC stack coolant (Pre-mixed)) passages.

Click hereEngine / Hybrid System>COOLING>COOLING SYSTEM>ON-VEHICLE INSPECTION


xviii.

Install the front compartment under cover assembly.

Click hereEngine / Hybrid System>FC CONTROL>FC STACK>INSTALLATION


xix.

Install the front lower suspension member protector.

Click hereEngine / Hybrid System>FC CONTROL>FC STACK>INSTALLATION


xx.

Install the front compartment under cover.

Click hereEngine / Hybrid System>FC CONTROL>FC STACK>INSTALLATION


xxi.

Install the FC stack cover sub-assembly.

Click hereEngine / Hybrid System>FC CONTROL>FC STACK>INSTALLATION


xxii.

Perform initialization procedures after replacing the FC cooling water ion exchanger element.

Click hereGeneral>MAINTENANCE>ION EXCHANGER ELEMENT>INSTALLATION