| *1 | RESERVE TANK CAP | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the FC air compressor with motor assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
1. PRECAUTION
2. CAUTIONS FOR COOLANT (TOYOTA GENUINE FC STACK COOLANT (Pre-mixed))
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
1A906
4.REMOVE FC STACK COVER SUB-ASSEMBLY
16A42
5.REMOVE FC COOLING WATER ION EXCHANGER ELEMENT
|
Pull Up Slowly | - | - |
Remove the reserve tank cap.
Using SST, loosen the FC cooling water ion exchanger element.
Slowly pull up the FC cooling water ion exchanger element, and remove it from the FC cooling water ion exchanger assembly.
| *1 | FC Cooling Water Ion Exchanger Assembly |
| *a | Separator |
Do not remove the separator on the bottom of the case. Reinstall the separator if it was removed.
If the vehicle is driven with the separator removed, the entire FC system may stop or the FC stack assembly may be damaged.
The coolant (Toyota genuine FC stack coolant (Pre-mixed)) will leak from the element so remove the element after the leaking has stopped .