Home › ADAS / AD › ADVANCED DRIVER ASSISTANCE SYSTEM › DYNAMIC RADAR CRUISE CONTROL SYSTEM
RM37H0E _95 ADAS / AD _095317 ADVANCED DRIVER ASSISTANCE SYSTEM _0455732 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

ADVANCED DRIVER ASSISTANCE SYSTEM  DYNAMIC RADAR CRUISE CONTROL SYSTEM  Steering Pad Switch Circuit  


DESCRIPTION

·

The cruise control main switch outputs the dynamic cruise control on/off signal and various control signals to the EV control ECU.

·

The EV control ECU controls the dynamic cruise control system according to the signals received from the cruise control main switch.


WIRING DIAGRAM

for RHD


C374512E36
4.125,2.583 5.26,3.135 1.135,0.552 10 false Spiral Cable Sub-assembly 1.052,2.594 3.271,2.958 2.219,0.365 10 false Steering Pad Switch Assembly 3.073,1.385 3.688,1.583 0.615,0.198 10 false MAIN 2.177,1.385 2.792,1.583 0.615,0.198 10 false CANCEL 1.313,1.385 1.927,1.583 0.615,0.198 10 false +RES 0.469,1.385 1.083,1.583 0.615,0.198 10 false -SET 3.844,2.083 4.156,2.281 0.313,0.198 10 false z5 3.854,0.875 4.167,1.073 0.313,0.198 10 false z5 3.885,0.656 4.115,0.885 0.229,0.229 10 false 2 3.833,1.875 4.104,2.052 0.271,0.177 10 false 12 4.667,0.792 5.125,0.99 0.458,0.198 10 false CCS 4.677,2 5.135,2.198 0.458,0.198 10 false ECC 5.521,0.885 5.979,1.083 0.458,0.198 10 false D32 5.521,2.083 5.979,2.281 0.458,0.198 10 false D32 5.563,0.667 5.875,0.885 0.313,0.219 10 false 13 5.604,1.875 5.76,2.073 0.156,0.198 10 false 2 6.417,0.885 6.875,1.083 0.458,0.198 10 false CCS 6.219,0.781 6.375,0.979 0.156,0.198 10 false 8 6.021,2.656 6.479,2.854 0.458,0.198 10 false D15 6.031,2.813 7.115,3.354 1.083,0.542 10 false EV Control ECU


for LHD


C374512E35
4.125,2.583 5.26,3.135 1.135,0.552 10 false Spiral Cable Sub-assembly 1.052,2.594 3.271,2.958 2.219,0.365 10 false Steering Pad Switch Assembly 3.073,1.385 3.688,1.583 0.615,0.198 10 false MAIN 2.177,1.385 2.792,1.583 0.615,0.198 10 false CANCEL 1.313,1.385 1.927,1.583 0.615,0.198 10 false +RES 0.469,1.385 1.083,1.583 0.615,0.198 10 false -SET 3.844,2.083 4.156,2.281 0.313,0.198 10 false z5 3.854,0.875 4.167,1.073 0.313,0.198 10 false z5 3.885,0.656 4.115,0.885 0.229,0.229 10 false 2 3.833,1.875 4.104,2.052 0.271,0.177 10 false 12 4.667,0.792 5.125,0.99 0.458,0.198 10 false CCS 4.677,2 5.135,2.198 0.458,0.198 10 false ECC 5.521,0.885 5.979,1.083 0.458,0.198 10 false D32 5.521,2.083 5.979,2.281 0.458,0.198 10 false D32 5.563,0.667 5.875,0.885 0.313,0.219 10 false 13 5.604,1.875 5.76,2.073 0.156,0.198 10 false 2 6.417,0.885 6.875,1.083 0.458,0.198 10 false CCS 6.219,0.781 6.375,0.979 0.156,0.198 10 false 8 6.021,2.656 6.479,2.854 0.458,0.198 10 false A8 6.031,2.813 7.115,3.354 1.083,0.542 10 false EV Control ECU


CAUTION / NOTICE / HINT

NOTICE:
·

Before replacing the EV control ECU, refer to Service Bulletin.

·

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



PROCEDURE

1.READ VALUE USING GTS (Radar Cruise1)
a.

Read the Data List according to the display on the GTS.

Powertrain > Radar Cruise1 > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Cancel Switch CANCEL switch status ON or OFF ON: CANCEL switch on
OFF: CANCEL switch off
-
-SET Switch -SET switch status ON or OFF ON: -SET switch on
OFF: -SET switch off
-
+RES Switch +RES switch status ON or OFF ON: +RES switch on
OFF: +RES switch off
-
Cruise Main Switch Operation Condition Cruise control main switch status ON or OFF ON: Cruise control main switch pushed
OFF: Cruise control main switch not pushed
-
Powertrain > Radar Cruise1 > Data List
Tester Display
Cancel Switch
-SET Switch
+RES Switch
Cruise Main Switch Operation Condition
50003 399 21,22,23,1
OK:

The value of each Data List item changes according to the operation of the cruise control main switch.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT STEERING PAD SWITCH ASSEMBLY
2.INSPECT STEERING PAD SWITCH ASSEMBLY

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION

Result:
Proceed to
OK
NG



OK

3.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

3.INSPECT SPIRAL CABLE SUB-ASSEMBLY

OK

4.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - EV CONTROL ECU AND BODY GROUND)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

4.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - EV CONTROL ECU AND BODY GROUND)
a.

Disconnect the D32 spiral cable sub-assembly connector.


b.

Disconnect the D15*1 or A8*2 EV control ECU connector.

*1: for RHD

*2: for LHD


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for RHD
Tester Connection Condition Specified Condition

Click Location & Routing(D32,D15)Location & Routing

Click Connector(D32)Instrument Panel>Instrument Panel Wire>Spiral Cable Sub-Assembly

Click Connector(D15)Instrument Panel>Instrument Panel Wire>EV Control ECU

D32-13 (CCS) - D15-8 (CCS) Always Below 1 Ω
D32-2 (ECC) - Body ground Always Below 1 Ω
D32-13 (CCS) or D15-8 (CCS) - Body ground Always 10 kΩ or higher

for LHD
Tester Connection Condition Specified Condition

Click Location & Routing(D32,A8)Location & Routing

Click Connector(D32)Instrument Panel>Instrument Panel Wire>Spiral Cable Sub-Assembly

Click Connector(A8)Instrument Panel>Front Compartment Main Wire>EV Control ECU

D32-13 (CCS) - A8-8 (CCS) Always Below 1 Ω
D32-2 (ECC) - Body ground Always Below 1 Ω
D32-13 (CCS) or A8-8 (CCS) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR