| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | STEERING KNUCKLE LH | 43212 | - | - | - |
| 2 | LOWER NO.2 SUSPENSION ARM ASSEMBLY LH | 48670A | ( )
|
- | - |
| 3 | FRONT LOWER BALL JOINT ASSEMBLY LH | 43340A | ( )
|
- | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front lower ball joint removal/installation are shown below.
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the front disc brake pads, the brake pedal may feel soft due to clearance between the front disc brake pads and front disc. Depress the brake pedal several times until the brake pedal feels firm.
When removing or installing the front disc brake cylinder assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C13DB00, C13DC00, C13DD00, C13DE00, C140000 and/or C140A00 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this procedure.
While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, theservo motor and expansion valve standardposition is recognized. | - |
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
43212
1.REMOVE STEERING KNUCKLE LH
43340A
3.REMOVE FRONT LOWER BALL JOINT ASSEMBLY LH
| *a | 2 mm (0.0787 in.) | - | - |
Remove the clip and nut.
Install SST (attachment) onto the front lower ball joint assembly LH so that there is a space of approximately 2 mm (0.0787 in.) between the arm and attachment.
Be sure to install SST (attachment) in order to prevent damage to the front lower ball joint assembly LH stud.
As SST may become damaged, make sure the space between the arm and spacers is not 2 mm (0.0787 in.) or less.
Using SST, disconnect the front lower ball joint assembly LH from the front lower suspension arm assembly LH.
Apply molybdenum grease to the bolt threads and end of the SST bolt.
Do not damage the dust cover of the front lower ball joint assembly LH.
Make sure that the bolt of SST and the front lower ball joint assembly LH are in a straight line when installing SST.
Be sure to tie the string of SST to the vehicle to prevent SST from dropping.
Do not apply a torque of 160 N*m (1631 kgf*cm, 118 ft.*lbf) or more to SST as it may be damaged.