| *1 | REAR NO. 2 SUSPENSION TOE ADJUST PLATE | *2 | REAR SUSPENSION ARM ATTACHMENT SUB-ASSEMBLY |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| ★ | Precoated part | - | - |
Use the same procedure for the RH and LH side.
The following procedure is for the LH side.
48740F
1.TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
Insert the rear suspension arm attachment sub-assembly from the back of the vehicle. Then temporarily tighten the rear No. 2 suspension toe adjust plate and rear No. 2 suspension arm assembly LH with the nut.
Insert the bolt from the front of the vehicle. Then temporarily tighten the rear No. 2 suspension arm assembly LH with the washer and nut.
48840A
2.TEMPORARILY TIGHTEN REAR STABILIZER LINK ASSEMBLY LH
89408C
3.CONNECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
48730
4.TEMPORARILY TIGHTEN LOWER CONTROL ARM ASSEMBLY LH
|
Bolt |
|
Nut |
Insert the bolt from the back of the vehicle. Then temporarily tighten the lower control arm assembly LH with the nut.
Temporarily tighten the lower control arm assembly LH with a new nut.
48730
6.FULLY TIGHTEN LOWER CONTROL ARM ASSEMBLY LH
|
Bolt |
|
Nut |
Fully tighten the lower control arm assembly LH with the bolt.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
Fully tighten the nut.
48740F
7.FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
Fully tighten the rear No. 2 suspension arm assembly LH with the nut.
Fully tighten the nut.
48840A
8.FULLY TIGHTEN REAR STABILIZER LINK ASSEMBLY LH
9.INSTALL REAR WHEEL
52296
10.INSTALL REAR SUSPENSION MEMBER BRACE LH
52295
11.INSTALL REAR SUSPENSION MEMBER BRACE RH
Use the same procedure as for the LH side.
53661B
12.INSTALL REAR SUSPENSION BRACE COVER
52384C
13.INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR
52383E
14.INSTALL NO. 1 DIFFERENTIAL SUPPORT PROTECTOR
15.INSPECT AND ADJUST REAR WHEEL ALIGNMENT
16.PERFORM INITIALIZATION