| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 1 EV BATTERY JUNCTION BLOCK ASSEMBLY | G92Z0A | ( )
|
- | - |
| 2 | NO. 1 EV BATTERY SHIELD SUB-ASSEMBLY | G920QB | ( )
|
- | - |
| 3 | UPPER EV BATTERY COVER PANEL | G92N1B | ( )
|
- | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 4 | EV SUPPLY BATTERY ASSEMBLY | G9510B | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 5 | FC CONVERTER POWER OUTLET CABLE (INVERTER WITH CONVERTER ASSEMBLY) | G9200A | ( )
|
- | - |
| 6 | FC STACK COVER SUB-ASSEMBLY | 1A906 | - | - | - |
| 7 | UPPER RADIATOR SUPPORT SEAL | 53292A | - | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 8 | SERVICE PLUG GRIP | G3834 | - | - | - |
| 9 | PERFORM CURRENT SENSOR OFFSET LEARNING | - | - | - | ( )
|
G92Z0A
1.INSTALL NO. 1 EV BATTERY JUNCTION BLOCK ASSEMBLY
|
|
Install the No. 1 EV battery junction block assembly with the 4 nuts.
Do not drop the No. 1 EV battery junction block assembly, strike it with tools or subject it to impact.
If the No. 1 EV battery junction block assembly is subjected to an impact, replace it with a new one.
Connect the 4 connectors.
Make sure that the connector is connected securely.
G9510B
4.INSTALL EV SUPPLY BATTERY ASSEMBLY
1A906
6.INSTALL FC STACK COVER SUB-ASSEMBLY
53292A
7.INSTALL UPPER RADIATOR SUPPORT SEAL
G3834
8.INSTALL SERVICE PLUG GRIP
9. PERFORM CURRENT SENSOR OFFSET LEARNING
|
|
Perform a road test.
Accelerate and decelerate gently. Avoid rapid acceleration and deceleration.
Drive the vehicle with the value of Data List item "Hybrid/EV Battery Current" between -50 A and 50 A.
| Tester Display |
|---|
| Hybrid/EV Battery Current |
Distance and driving time are not specified.
Turn the ignition switch off and leave the vehicle for 30 seconds or more.
Check that the value of "Hybrid/EV Battery Current" is between -0.5 A and 0.5 A with the ignition switch on (IG).
| Tester Display |
|---|
| Hybrid/EV Battery Current |
If the value is outside the specified range, perform the road test again.
When the ignition switch is on (IG), if value of "Hybrid/EV Battery Current" is between -0.5 A and 0.5 A, current sensor offset learning has been completed.
Even if the current sensor offset learning is not complete, the current sensor value will be corrected by repeating the road test a maximum of 7 times.