| X2005
|
Hybrid/EV Powertrain Control System Malfunction
|
History of a malfunction in the HV system
|
·
Brake system warning light (yellow indicator) illuminates
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to the following diagnosis procedure:
1.
Using the GTS, perform a Health Check.
2.
Refer to the flow chart(s) for the output DTCs.
|
| X204C
|
Zero Point Calibration of Yaw Rate Sensor Undone
|
History of incomplete yaw rate sensor zero point calibration
|
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to Zero Point Calibration of Yaw Rate Sensor Undone (X204C).
( )
|
| X2079
|
Communication Error from Brake Control Module to Engine Control Module
|
History of being unable to send data to the ECM continuously for 2 seconds or more
|
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to the following diagnosis procedure:
1.
Using the GTS, perform a Health Check.
2.
Refer to the flow chart(s) for the output DTCs.
|
| X2085
|
Electric Parking Brake Control Module Malfunction
|
History of receiving an electric parking brake system malfunction signal continuously for 1 second or more from the No. 2 skid control ECU (brake actuator assembly)
|
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to How to Proceed with Troubleshooting in Electric Parking Brake System.
( )
|
| X2086
|
SRS Airbag Malfunction
|
History of receiving a malfunction signal output for a secondary collision brake control request from the airbag ECU assembly 2 consecutive times
|
-
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to How to Proceed with Troubleshooting in Airbag System.
( )
|
| X2087
|
Engine Malfunction
|
History of receiving an FC control system malfunction signal continuously from the ECM for 1 second or more
|
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Refer to How to Proceed with Troubleshooting in FC control System.
|
| X2088
|
Bank Angle Detected
|
History of VSC operation being temporarily prohibited when driving at a steep bank angle, etc.
|
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
- HINT:
-
Explain that VSC operation was temporarily prohibited when driving on a road with a steep bank angle, etc.
|
| X208A
|
Zero Point Calibration of Steering Angle Sensor Initialization Malfunction
|
History of being unable to obtain the steering angle zero point after driving at a vehicle speed exceeding 15 km/h (9 mph) for 0.05 seconds or more
|
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to the following diagnosis procedure:
1.
Perform steering sensor zero point calibration.
|
| X208B
|
EPB Motor Continuous Operation Request
|
History of system suspended to prevent overheat of parking brake actuator assembly when electric parking brake was used repeatedly
|
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
- HINT:
·
EPB: Electric Parking Brake System
·
Explain that system was suspended to prevent overheating of parking brake actuator assembly when electric parking brake was used repeatedly.
|
| X2096
|
Pre-Collision Brake
|
History of pre-collision brake operation
|
In accordance with Pre-collision System behavior
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly)
|
| X2098
|
Pre-Collision Brake Assist
|
History of pre-collision brake assist operation
|
In accordance with Pre-collision System behavior
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly)
|
| X20A0
|
ABS
|
History of ABS operation
|
Slip indicator light blinks
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly)
|
| X20A1
|
VSC
|
History of VSC operation
|
Slip indicator light blinks
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly)
|
| X20A2
|
TRC(TRAC)
|
History of TRC operation
|
Slip indicator light blinks
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly)
|
| X20A5
|
Hill Start Assist
|
History of hill start assist operation
|
-
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly)
|
| X20A7
|
Brake Assist
|
History of brake assist operation
|
-
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly)
|
| X20A8
|
Secondary Collision Brake
|
History of secondary collision brake operation
|
-
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly)
|
| X20A9
|
ABS Continuous Operation Request
|
History of ABS being operated for 60 seconds or more
|
·
Brake system warning light (yellow indicator) illuminates
·
Brake system warning light (red indicator) illuminates
·
ABS warning light illuminates
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly)
|
| X20AA
|
VSC Continuous Operation Request
|
History of VSC being operated for 10 seconds or more
|
·
Brake system warning light (yellow indicator) illuminates
·
Brake system warning light (red indicator) illuminates
·
ABS warning light illuminates
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) and No. 2 skid control ECU (brake actuator assembly)
|
| X20D7
|
Zero Point Calibration of Steering Angle Sensor Malfunction
|
History of the steering sensor zero point calibration position differing from the stored value
|
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to Zero Point Calibration of Steering Angle Sensor Malfunction (X20D7).
( )
|
| X20D8
|
Zero Point Calibration of Steering Angle Sensor Not Acquired
|
History of being unable to obtain the steering angle zero point
|
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to Zero Point Calibration of Steering Angle Sensor Not Acquired (X20D8).
( )
|
| X219C
|
EPB Lock Control Run
|
History of abnormal EPB operation
|
Brake system warning light (yellow indicator) illuminates
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
- HINT:
-
EPB: Electric Parking Brake System
|
| X21A9
|
ACC Low Pressure
|
History of a continuous and significant decrease in accumulator pressure
|
·
Brake system warning light (yellow indicator) illuminates
·
Brake system warning light (red indicator) illuminates
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly)
Refer to ACC Low Pressure (X21A9).
( )
|
| X21D0
|
Brake Pedal Position Sensor "A" Performance Malfunction
|
History of malfunction of brake pedal stroke sensor 1
|
·
Brake system warning light (yellow indicator) illuminates
·
Brake system warning light (red indicator) illuminates
·
ABS warning light illuminates
·
Slip indicator light illuminates
·
Brake hold operated indicator light blinks*1
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to the following diagnosis procedure:
1.
Using the GTS, perform a Health Check.
2.
Refer to the flow chart(s) for the output DTCs.
|
| X21D1
|
Brake Pedal Position Sensor "B" Performance Malfunction
|
History of malfunction of brake pedal stroke sensor 2
|
·
Brake system warning light (yellow indicator) illuminates
·
Brake system warning light (red indicator) illuminates
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly)
Refer to the following diagnosis procedure:
1.
Using the GTS, perform a Health Check.
2.
Refer to the flow chart(s) for the output DTCs.
|
| X21D2
|
Brake Pressure Sensor / Brake Pedal Position Sensor Signal Compare Failure
|
History of mismatch between brake pedal stroke sensor assembly and reaction force pressure sensor.
|
·
Brake system warning light (yellow indicator) illuminates
·
Brake system warning light (red indicator) illuminates
|
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly)
Refer to Brake Pressure Sensor / Brake Pedal Position Sensor Signal Compare Failure (X21D2).
( )
- NOTICE:
-
If the detection conditions for X21D2 are met 3 times in a row in the same trip, DTC P05FF62 is stored.
( )
|
| X261B
|
Software Inconsistency with PCS Module
|
History of mismatch between the specification information sent by the forward recognition camera*3 or object recognition camera*4 and the specification information stored in the No. 2 skid control ECU (brake actuator assembly)
|
-
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
Refer to the following diagnosis procedure:
1.
Using the GTS, perform a Health Check.
2.
Refer to the flow chart(s) for the output DTCs.
|
| X280E
|
Side Wind Suppression Control Operation Request
|
History of side wind suppression control operation
|
-
|
- HINT:
-
When the side wind suppression control operating, the slip indicator light blinks.
|
| XF01B
|
ECU Security Key Not Registered
|
ECU security key has not been registered
|
*2
|
Output ECU: No. 2 skid control ECU (brake actuator assembly)
( )
|