Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID BATTERY SYSTEM
RM37H0E _51 Engine / Hybrid System _096346 HYBRID / BATTERY CONTROL _0453477 HYBRID BATTERY SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID BATTERY SYSTEM  P300000  Hybrid/EV Battery Discharge Control Malfunction  


DESCRIPTION

The battery ECU assembly alerts the driver and performs fail-safe control based on malfunction signals. If the SOC drops due to running out of fuel, or a hybrid control system malfunction, this DTC will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
P300000 Hybrid/EV Battery Discharge Control Malfunction Discharging of the EV supply battery assembly continues even after discharging is prohibited when the "SOC" has reached the lower limit.
(1 trip detection logic)
·

FC system

·

Hydrogen level

·

EV battery state of charge


Master Warning:
Does not come on
EV Battery A

Related Data List
DTC No. Data List
P0C3000
·

Hybrid/EV Battery SOC

·

Hybrid/EV Battery Current



CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>UTILITY


1.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

2.

Turn the ignition switch off and wait for 10 minutes or more.

3.

Turn the ignition switch to ON (READY) with park (P) selected and cause the "Hybrid/EV Battery SOC" to decrease. Check that the FC system is started to charge the EV supply battery assembly, and the value of Data List item "Hybrid/EV Battery SOC" increases and then remains within an appropriate range.

HINT:

FC system is started: "FC Work Mode" is displayed for the Data List (EV) item "Working" and "FC Intermittent Operation" is OFF.


4.

Enter the following menus: Powertrain / EV Battery / Utility / All Readiness.

5.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE, perform driving pattern again.




CAUTION / NOTICE / HINT

HINT:
·

When the FC system cannot be started, DTC P300000 may be stored because the EV supply battery assembly cannot be charged.

·

Repeated FC system start checks may cause the SOC to drop, resulting in DTC P300000 being stored. In this case, charge the EV supply battery assembly using the THS charger.

·

Starting the FC system once causes the SOC to drop approximately 1%.

·

Charging the EV supply battery assembly once (10 minutes) using the THS charger restores the SOC approximately 2%.

·

Charging the EV supply battery assembly using the THS charger takes approximately 10 minutes when the battery temperature is 25°C (77°F) or approximately 30 minutes when the battery temperature is 0°C (32°F).

·

The THS charger is a supplemental charging device that enables the FC system to start (READY-on state).

·

The FC system may fail to start and charging may be prohibited at extremely low temperatures (below the freezing point).

In this case, a vehicle control history code "X3102" is stored.

Click hereEngine / Hybrid System>FC CONTROL>FC CONTROL SYSTEM>VEHICLE CONTROL HISTORY (RoB)



PROCEDURE

1.CHECK DTC OUTPUT (EV BATTERY)

Pre-procedure1

a.

None.


Procedure1

a.

Check for DTCs.

Powertrain > EV Battery > Trouble Codes
50001 398

Result:
Result Proceed to
Only P300000 or P300016 is output A
P300000 or P300016 and other DTCs are output B


Post-procedure1

a.

Turn the ignition switch off.



A

2.CHECK DTC OUTPUT (EV)

B

GO TO DTC CHART (HYBRID BATTERY SYSTEM)

2.CHECK DTC OUTPUT (EV)

Pre-procedure1

a.

None.


Procedure1

a.

Check for DTCs.

Powertrain > EV > Trouble Codes
50001 397

Result:
Result Proceed to
DTCs are not output A
DTCs are output B


Post-procedure1

a.

Turn the ignition switch off.



A

3.CHECK DTC OUTPUT (FC)

B

3.CHECK DTC OUTPUT (FC)

Pre-procedure1

a.

None.


Procedure1

a.

Check for DTCs.

Powertrain > FC > Trouble Codes
50001 490

Result:
Result Proceed to
DTCs are not output A
DTCs are output B


Post-procedure1

a.

Turn the ignition switch off.



A

4.CHECK FOR VEHICLE CONTROL HISTORY (FC CONTROL SYSTEM)

B

4.CHECK FOR VEHICLE CONTROL HISTORY (FC CONTROL SYSTEM)

Pre-procedure1

a.

None.


Procedure1

a.

Check for Vehicle Control History.

Powertrain > EV > Utility
Tester Display
Vehicle Control History (RoB)
50005 397 55

Result:
Result Proceed to
Vehicle Control History Code "X3102" is not stored A
Vehicle Control History Code "X3102" is stored B


Post-procedure1

a.

Turn the ignition switch off.



A

5.CHECK AMOUNT OF HYDROGEN

B

GO TO VEHICLE CONTROL HISTORY (FC CONTROL SYSTEM)

5.CHECK AMOUNT OF HYDROGEN

Pre-procedure1

a.

Turn the ignition switch to ON.


Procedure1

a.

Check the amount of hydrogen by referring to the fuel gauge in the meter.


Result:
Result Proceed to
Proper amount of hydrogen is in the tank. A
There is no hydrogen in the tank. B


HINT:

Add hydrogen until the low fuel level warning light turns off.


Post-procedure1

a.

Turn the ignition switch off.



A

6.CHECK FC SYSTEM START

B

REFUEL VEHICLE

6.CHECK FC SYSTEM START

Pre-procedure1

a.

Turn the ignition switch to ON (READY).


Procedure1

a.

Check if the FC system starts.

Powertrain > EV > Data List
Tester Display
FC Work Mode
FC Intermittent Operation
50003 397 962,872
HINT:
·

FC system is started: "FC Work Mode" is displayed for the Data List (EV) item "Working" and "FC Intermittent Operation" is OFF.

·

Depressing the accelerator pedal with park (P) selected will cause the FC system to start.

·

Turning the ignition switch to ON (READY) and off repeatedly while the SOC is low may cause the SOC to drop further, resulting in DTC P300016 being stored. Charge the EV supply battery assembly using the THS charger as necessary.

·

Starting the FC system once causes the SOC to drop approximately 1%.

·

Charging the EV supply battery assembly once (10 minutes) using the THS charger restores the SOC approximately 2%.




Result:
Result Proceed to
The FC system does not start. A
The FC system starts. B


Post-procedure1

a.

Turn the ignition switch off.



A

7.CLEAR DTC (EV BATTERY)

B

LEAVE VEHICLE WITH PARK (P) SELECTED, CONTINUE TO CHARGE THE VEHICLE UNTIL FC INTERMITTENT OPERATION BECOMES ON

7.CLEAR DTC (EV BATTERY)

Pre-procedure1

a.

None.


Procedure1

a.

Clear the DTCs and freeze frame data.

Powertrain > EV Battery > Clear DTCs
50002 398

Result:
Proceed to
NEXT


Post-procedure1

a.

Turn the ignition switch off.



NEXT

CHARGE EV SUPPLY BATTERY ASSEMBLY

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HV BATTERY>CHARGING

a.

Charge the EV supply battery assembly using the THS charger, then check that FC system starts.

HINT:

FC system is started: "FC Work Mode" is displayed for the Data List (EV) item "Working" and "FC Intermittent Operation" is OFF.