| *A | for Driver Side | *B | for Front Passenger Side |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front door No. 4 stripe and front door No. 3 stripe removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
3.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
4.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
67492A
6.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
68193C
8.REMOVE FRONT DOOR FRONT BELT SEAL LH
10.REMOVE HOLE PLUG
68151C
12.REMOVE FRONT DOOR GLASS RUN LH
67664
13.REMOVE UPPER DOOR FRAME GARNISH LH
67862
14.DISCONNECT FRONT DOOR WEATHERSTRIP LH
75966B
15.REMOVE FRONT DOOR NO. 4 STRIPE LH
Heat the adhesive of the front door No. 4 stripe LH using a heat light.
| Part | Temperature |
|---|---|
| Front Door No. 4 Stripe LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front door No. 4 stripe LH excessively.
Remove the front door No. 4 stripe LH.
75986B
16.REMOVE FRONT DOOR NO. 3 STRIPE LH
Heat the adhesive of the front door No. 3 stripe LH using a heat light.
| Part | Temperature |
|---|---|
| Front Door No. 3 Stripe LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front door No. 3 stripe LH excessively.
Remove the front door No. 3 stripe LH.