Home › Engine / Hybrid System › FC CONTROL › FC CONTROL SYSTEM
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466766 FC CONTROL SYSTEM C

FC CONTROL  FC CONTROL SYSTEM  P1D2F00  FC Coolant Pump Performance  


DESCRIPTION

The cooling system of the FC system controls the FC stack temperature so that it can remain at optimum for power generation. The cooling system employs the FC cooling water pump assembly to feed the FC stack with a necessary amount of FC stack coolant so that the FC stack temperature can remain at an appropriate level, and it forces a heated FC stack coolant at the FC stack outlet to flow into the radiator, cooling down and recirculating the FC stack coolant.

If the FC cooling water pump assembly idles due to an insufficient coolant level, the power consumption of the FC cooling water pump assembly will decrease.

A479010C02
4.552,0.521 4.865,0.719 0.313,0.198 10 false *1 4.104,0.292 4.417,0.49 0.313,0.198 10 false *2 2.625,0.26 2.938,0.458 0.313,0.198 10 false *3 2.229,2.365 2.542,2.563 0.313,0.198 10 false *4 0.458,1.354 0.771,1.552 0.313,0.198 10 false *5 5.771,3.5 6.208,3.708 0.438,0.208 10 false *13 3.802,2.719 4.229,2.927 0.427,0.208 10 false *12 2.417,1.302 2.729,1.5 0.313,0.198 10 false *6 0.813,0.073 1.125,0.271 0.313,0.198 10 false *7 3.75,1.813 4.063,2.01 0.313,0.198 10 false *8 3.208,3.448 3.594,3.667 0.385,0.219 10 false *9 5.396,1.469 5.781,1.688 0.385,0.219 10 false *10 5.417,2.271 5.802,2.49 0.385,0.219 10 false *11 6.333,2.563 6.729,2.865 0.396,0.302 10 false *14
*1 FC Stack *2 FC Stack Assembly
*3 FC Cooling Water Pump Assembly *4 FC Cooling Water Temperature Control Valve
*5 FC Radiator Assembly *6 FC Cooling Water Ion Exchanger Assembly
*7 Water Temperature Sensor (for Radiator Outlet Side) *8 Water Temperature Sensor (for FC Stack Outlet Side)
*9 Intercooler *10 Hydrogen Recirculation Pump Assembly
*11 Exhaust Drainage Valve *12 Water Pump Assembly with Motor
*13 Heater Radiator Unit Sub-assembly *14 Electric Heater Sub-assembly


DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
P1D2F00 FC Coolant Pump Performance When the power consumption of the FC cooling water pump assembly is considerably less than the value estimated based on the speed of the FC cooling water pump assembly, the coolant temperature and the rotary valve opening angle, the system is determined to be malfunctioning.
(1 trip detection logic)
·

Amount of FC stack coolant

·

FC stack coolant piping (leakage)

·

Rreserve tank cap

·

FC cooling water pump assembly


Master Warning: Comes on EV B

HINT:
·

This DTC indicates an insufficient amount of FC stack coolant, FC stack coolant leaks, or malfunctions in the FC cooling water temperature control valve or in the cooling fan controller with motor. If a coolant temperature increases high, the FC system output will be limited.

·

If the FC stack coolant volume decreases, the power consumption of the FC cooling water pump assembly is reduced.



Detection timing
Vehicle Condition FC shutdown
(ignition switch ON)
FC startup process FC intermittent operation FC is generating power
(vehicle is in stationary)
FC is generating power
(vehicle is traveling)
FC shutdown process
Data List
"FC Work Mode"
Stop Startup Working Finishing
Data List
"FC Intermittent Operation"
OFF ON OFF OFF
DTC Detection - - - - ○ -

HINT:

By accessing the "FC Work Mode" and "FC Intermittent Operation" in the freeze frame data, the FC system condition at the time the malfunction occurred can be checked.


Related Data List
DTC No. Data List
P1D2F00
·

Target Radiator Rotary Valve Position

·

Radiator Rotary Valve Position

·

FC Coolant Pump Speed

·

Target FC Coolant Pump Speed

·

FC Coolant Pump Consumption Power

·

FC Stack Outlet Coolant Temperature (Filtered Value)

·

Radiator Outlet Coolant Temperature (Filtered Value)



Related Active Test
DTC No. Active Test
P1D2F00
·

Control the Radiator Fan 1

·

Control the Radiator Rotary Valve

·

Control the FC Coolant Pump



CAUTION / NOTICE / HINT

NOTICE:
·

This vehicle performs FC system shutdown process after turning the ignition switch off from ON (READY). Therefore, after the ignition switch is turned off from ON (READY), do not perform any work on the electrical system for at least 10 minutes including removing connectors or disconnecting the negative (-) auxiliary battery terminal.

·

When the EV control ECU determines that the temperature of FC system components is below 0°C (32°F) when the vehicle is parked with the ignition switch off, it operates the FC air compressor, hydrogen pump and FC cooling water pump for a maximum of 180 seconds to drain the FC stack assembly. When performing inspection or repairs with the ignition switch off (not ON or ON (READY)), disconnect the cable from the negative (-) auxiliary battery terminal before performing work. (If the auxiliary battery voltage is needed to conduct inspection, perform the inspection in an environment with an ambient temperature of 10°C (50°F) or higher.)



HINT:
·

Forcing the SOC of the EV supply battery assembly to decrease by applying electrical loads such as turning on the air conditioning (HOT MAX, maximum airflow), or depressing the accelerator pedal with the shift state in park (P), the "FC Intermittent Operation" of the Data List is easily to enter OFF (power generation mode).


After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Drive the vehicle for 10 minutes according to the freeze frame data (Vehicle Speed, Accelerator Degree).

CAUTION:

Perform this road test only in an appropriate safe location, in accordance with all local laws.




PROCEDURE

1.CHECK DTC OUTPUT
NOTICE:

The freeze frame data is cleared when DTCs are cleared. Be sure to make a note of necessary data in advance.


Pre-procedure1

a.

None


Procedure1

a.

According to the display on the GTS, check for DTCs in the Health Check.

Result:
Result Proceed to
Only P1D2F00 is output A
P1D2F00 is output and DTCs other than the DTCs in the table below are output B
P1D2F00 is output and any DTCs in the table below are output C

Malfunction Content Relevant DTC
Microcomputer malfunction/Power source circuit malfunction P1DC896 (EV) FC Coolant Pump Inverter Component Internal Failure
Communication system malfunction P1DC887 (EV) Lost Communication with FC Coolant Pump Inverter Missing Message
Sensor and actuator circuit malfunction P1D251C (EV) Radiator Outlet Coolant Temperature Sensor Circuit Voltage Out of Range
P1D2A1C (EV) FC Stack Outlet Coolant Temperature Sensor Circuit Voltage Out of Range
P1D2F96 (EV) FC Coolant Pump Component Internal Failure
P1DD514 (FC) Radiator Rotary Valve Circuit 1 Circuit Short to Ground or Open
P1EFD14 (FC) Radiator Rotary Valve Circuit 2 Circuit Short to Ground or Open
P1EFE14 (FC) Radiator Rotary Valve Circuit 3 Circuit Short to Ground or Open
P1EFF14 (FC) Radiator Rotary Valve Circuit 4 Circuit Short to Ground or Open


HINT:

DTC P1D2F00 may be store due to problems that cause the DTCs shown above to output. If such happens, troubleshoot the suspected area(s) corresponding to the output DTC(s) in order of the listed DTCs shown in the table above.



Post-procedure1

a.

Turn the ignition switch off.



A

2.CLEAR DTC

B

2.CLEAR DTC

C

GO TO DTC CHART

2.CLEAR DTC

Pre-procedure1

a.

None


Procedure1

a.

Clear the DTCs.

Powertrain > EV > Clear DTCs
50002 397
Result:
Proceed to
NEXT



Post-procedure1

a.

Turn the ignition switch off and wait for 10 minutes or more.



NEXT

3.INSPECT RESERVE TANK CAP
3.INSPECT RESERVE TANK CAP

Pre-procedure1

a.

None


Procedure1

a.

Check that the reserve tank cap is correctly installed to the FC radiator reserve tank.


b.

Inspect the reserve tank cap.

Click hereEngine / Hybrid System>COOLING>RADIATOR>ON-VEHICLE INSPECTION


Result:
Proceed to
OK
NG


Post-procedure1

a.

None



OK

4.CHECK COOLANT (FC STACK COOLANT) LEAK

NG

INSTALL OR REPLACE RESERVE TANK CAP

4.CHECK COOLANT (FC STACK COOLANT) LEAK

Pre-procedure1

a.

Check the FC stack coolant level in the FC radiator reserve tank.


Procedure1

a.

Check for FC coolant leaks.

Click hereEngine / Hybrid System>COOLING>COOLING SYSTEM>ON-VEHICLE INSPECTION

Result:
Result Proceed to
No leaks are found and the FC coolant level in the FC radiator reserve tank is above the low line. A
No leaks are found and the FC coolant level in the FC radiator reserve tank is below the low line. B
FC coolant leaks are evident. C


HINT:
·

After repairing the FC coolant leaks and adding coolant, perform the "Control the FC Coolant Pump" and "Control the Radiator Fan 1" Active Test and make sure that there are no malfunctions.

·

If a coolant leak cannot be found despite that the coolant in the radiator reserve tank is below the Low level, leakage may have occurred inside the FC stack or in the air conditioning system.

·

If there is a leak in the FC stack, DTC P0AA649 may be output to the EV control ECU.




Post-procedure1

a.

None



A

5.CHECK COOLANT HOSE

B

9.ADD FC STACK COOLANT

C

INSPECT COOLANT LEAK AND ADD COOLANT

5.CHECK COOLANT HOSE
a.

Check that the cooling system hoses are not kinked or clogged.

OK:

The cooling system hoses are not kinked or clogged



Result:
Proceed to
OK
NG



OK

6.PERFORM ACTIVE TEST USING GTS (CONTROL THE RADIATOR FAN 1)

NG

REPAIR OR REPLACE COOLANT HOSE

6.PERFORM ACTIVE TEST USING GTS (CONTROL THE RADIATOR FAN 1)

Pre-procedure1

a.

None


Procedure1

a.

Perform the Active Test.

Powertrain > EV > Active Test
Active Test Display
Control the Radiator Fan 1
Data List Display
Radiator Fan 1 Drive Voltage
50004 397 18 705
OK:

The cooling fan rotates


Result:
Proceed to
OK
NG



Post-procedure1

a.

Turn the ignition switch off.



OK

7.PERFORM ACTIVE TEST USING GTS (CONTROL THE FC COOLANT PUMP)

NG

7.PERFORM ACTIVE TEST USING GTS (CONTROL THE FC COOLANT PUMP)

Pre-procedure1

a.

Turn the ignition switch to ON (READY).


Procedure1

a.

Check that "FC Stack Outlet Coolant Temperature (Filtered Value)" is 40°C or more.

Powertrain > EV > Active Test
Active Test Display
Control the FC Coolant Pump
Data List Display
FC Coolant Pump Drive Speed
FC Coolant Pump Speed
Target FC Coolant Pump Speed
FC Stack Outlet Coolant Temperature (Filtered Value)
50004 397 17 704,909,908,998
HINT:

If 40°C or less, drive the vehicle on urban roads for approximately 10 minutes to warm it up.



b.

Perform the Active Test for 10 seconds or more at 3100 rpm.


Result:
Proceed to
NEXT


Post-procedure1

a.

None



NEXT

8.CHECK DTC OUTPUT
8.CHECK DTC OUTPUT

Pre-procedure1

a.

None


Procedure1

a.

Check for DTCs.

Powertrain > EV > Trouble Codes
50001 397
Result:
Result Proceed to
P1D2F00 is output A
DTCs are not output B



Post-procedure1

a.

Turn the ignition switch off.



A

REPLACE FC COOLING WATER PUMP ASSEMBLY

B

9.ADD FC STACK COOLANT

Pre-procedure1

a.

None


b.

Add FC stack coolant and bleed air.


Procedure1

a.

After bleeding air, check the coolant level and check for coolant leaks again.

OK:

No leaks are found and the FC coolant level in the FC radiator reserve tank is above the low line.


HINT:
·

After repairing the FC coolant leaks and adding coolant, perform the "Control the FC Coolant Pump" and "Control the Radiator Fan 1" Active Test and make sure that there are no malfunctions.

·

If a coolant leak cannot be found despite that the coolant in the radiator reserve tank is below the Low level, leakage may have occurred inside the FC stack or in the air conditioning system.

In this case, add coolant and then bleed air from the coolant. If the coolant level is still too low but a coolant leak cannot be confirmed even in the air conditioning system, the coolant leak is in the FC stack. Replace the FC stack.

·

If there is a leak in the FC stack, DTC P0AA649 may be output to the EV control ECU.



Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

END

NG

REPLACE FC STACK ASSEMBLY