| *A | w/ Double Locking System | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door lower outside stripe, rear door stripe outside and rear inner black out tape removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
Use the same procedure for both the RH and LH side.
The procedure described below is for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
68174A
5.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
89225
8.REMOVE MULTIPLEX NETWORK DOOR REAR ECU (w/ Double Locking System)
67646A
9.REMOVE REAR DOOR ARMREST SET BRACKET LH
68152C
11.REMOVE REAR DOOR GLASS RUN LH
68124B
13.REMOVE REAR DOOR QUARTER WINDOW GLASS LH
67674B
15.REMOVE REAR DOOR FRAME GARNISH LH
67872
16.DISCONNECT REAR DOOR WEATHERSTRIP LH
75978H
17.REMOVE REAR DOOR LOWER OUTSIDE STRIPE LH
Heat the adhesive of the rear door lower outside stripe LH using a heat light.
| Part | Temperature |
|---|---|
| Rear Door Lower Outside Stripe LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear door lower outside stripe LH excessively.
Remove the rear door lower outside stripe LH.
75988E
18.REMOVE REAR DOOR STRIPE OUTSIDE LH
Heat the adhesive of the rear door stripe outside LH using a heat light.
| Part | Temperature |
|---|---|
| Rear Door Stripe Outside LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear door stripe outside LH excessively.
Remove the rear door stripe outside LH.
75954A
19.REMOVE REAR INNER BLACK OUT TAPE LH
Heat the adhesive of the rear inner black out tape LH using a heat light.
| Part | Temperature |
|---|---|
| Rear Inner Black Out Tape LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear inner black out tape LH excessively.
Remove the rear inner black out tape LH.