| *A | w/ Rear Door Sunshade | - | - |
| *A | w/ Double Locking System or w/ Easy Closer | - | - |
| *A | w/ Easy Closer | *B | w/o Easy Closer |
| ● | Non-reusable part | - | - |
| *A | w/ Rear Door Sunshade | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door disassembly/reassembly are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When removing the front door glass sub-assembly, move the front door glass sub-assembly to the lowest position before disconnecting the auxiliary battery negative (-) terminal.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
|
|
69284D
3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
Using moulding remover A, detach the claws and remove the rear door inside handle bezel plug.
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
|
Remove in this Order | - | - |
Using moulding remover A, detach the claw and remove the rear power window regulator switch assembly with rear door armrest base panel.
Disconnect the connectors.
67604
5.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
|
Place Hands Here |
|
Remove in this Direction |
Remove the 3 screws.
Place your hand at the position shown in the illustration, detach the clip.
Pull the rear door trim board sub-assembly shown in the illustration, detach the claws and guides and remove the rear door trim board sub-assembly from the front door panel.
|
Remove in this Direction |
|
Push |
Detach the clamps and disconnect the open lever front door lock remote control cable from the rear door inside handle sub-assembly.
Disconnect the connectors.
Detach the claws and clamps, disconnect the lock/unlock knob rear door inside locking cable.
81230
6.REMOVE COURTESY LIGHT ASSEMBLY
65908D
7.REMOVE REAR CURTAIN SUB-ASSEMBLY (w/ Rear Door Sunshade)
|
Remove in this Direction | - | - |
81080V
8.REMOVE NO. 2 INTERIOR ILLUMINATION LIGHT ASSEMBLY
69206C
9.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY
|
Remove in this Direction | - | - |
68174A
10.REMOVE REAR DOOR GLASS INNER WEATHERSTRIP
|
Remove in this Direction | - | - |
68197A
11.REMOVE REAR DOOR BELT FRONT SEAL
|
Remove in this Direction | - | - |
Using a clip remover, detach the clips.
Peel back the rear door belt fron seal and disengage the guide as shown in the illustration.
Remove the rear door belt front seal as shown in the illustration.
68199
12.REMOVE REAR DOOR BELT REAR SEAL
|
Remove in this Direction | - | - |
Using a clip remover, detach the clip and turn over the rear door glass weatherstrip inner LH partially.
Remove the rear door belt rear seal as shown in the illustration.
86160B
13.REMOVE REAR SPEAKER ASSEMBLY
89225
14.REMOVE MULTIPLEX NETWORK DOOR REAR ECU (w/ Double Locking System or w/ Easy Closer)
|
Screw |
|
Connector |
67646A
15.REMOVE REAR DOOR ARMREST SET BRACKET
67842E
16.REMOVE REAR DOOR SERVICE HOLE COVER
|
Protective Tape | - | - |
Disconnect the connector.
Disconnect the wire harness clamps.
Using a clip remover with its tip wrapped in protective tape, detach the clips.
Remove the lock / unlock knob rear door inside locking cable and open lever rear door lock remote control cable from rear door service hole cover.
17.REMOVE HOLE PLUG
68152C
18.REMOVE REAR DOOR GLASS RUN
67408E
19.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
|
Remove in this Direction | - | - |
Lift up the rear door weatherstrip as shown in the illustration.
Remove the screws.
Remove the 2 bolts and rear door window division bar sub-assembly.
68124B
20.REMOVE REAR DOOR QUARTER WINDOW GLASS
|
Remove in this Direction | - | - |
68189
21.REMOVE REAR DOOR QUARTER WINDOW WEATHERSTRIP
68104
22.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
Connect the 2 connectors to the multiplex network door rear ECU.
Connect the connector to the rear power window regulator switch.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch on.
Move the rear door glass sub-assembly so that the door glass installation position can be seen.
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If an SRS part is accidentally deployed, it may cause a serious injury.
Disconnect the connector from the rear pawer window regulator switch.
Disconnect the 2 connectors from the multiplex network door rear ECU.
|
Remove in this Direction | - | - |
Move the rear door glass sub-assembly and remove the rear door glass sub-assembly.
Remove the rear door glass sub-assembly as shown in the illustration.
Do not damage the rear door glass.
67674B
23.REMOVE REAR DOOR FRAME GARNISH
|
Remove in this Direction | - | - |
69804
24.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY
|
Bolt |
|
Connector |
69730M
27.REMOVE OPEN LEVER REAR DOOR LOCK REMOTE CONTROL CABLE (w/o Easy Closer)
69770E
28.REMOVE LOCK / UNLOCK KNOB REAR DOOR INSIDE LOCKING CABLE (w/o Easy Closer)
69730M
31.REMOVE OPEN LEVER REAR DOOR LOCK REMOTE CONTROL CABLE (w/ Easy Closer)
69770E
32.REMOVE LOCK / UNLOCK KNOB REAR DOOR INSIDE LOCKING CABLE (w/ Easy Closer)
69318D
33.REMOVE DOOR LOCK WIRING HARNESS SEAL
When re-using the rear door lock assembly:
69240
34.REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY
|
Remove in this Direction | - | - |
Using a thin-bladed screwdriver with its tip wrapped with protective tape, detach the claws and disconnect the connector cover as shown in the illustration.
Using a thin-bladed screwdriver with its tip wrapped with protective tape, disconnect the connector as shown in the illustration.
Disengage the 2 claws and move the lever as shown in the illustration.
Remove the rear door outside handle assembly as shown in the illustration.
69227L
35.REMOVE REAR DOOR OUTSIDE HANDLE COVER
|
Remove in this Direction | - | - |
Using a T30 "TORX" socket wrench, loosen the screw to remove the door outside handle cover.
69241G
36.REMOVE REAR DOOR OUTSIDE HANDLE FRONT PAD
|
Remove in this Direction | - | - |
69242G
37.REMOVE REAR DOOR OUTSIDE HANDLE REAR PAD
|
Remove in this Direction | - | - |
69204A
38.REMOVE REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY
| *a | Inside of the vehicle | *b | Outside of the vehicle |
Using a T30 "TORX" socket wrench, loosen the screw.
Detach the guide and remove the rear door outside handle frame sub-assembly.
68640A
39.REMOVE REAR DOOR CHECK ASSEMBLY
|
Nut |
|
Bolt |
67872
40.REMOVE REAR DOOR WEATHERSTRIP
|
Protective Tape | - | - |
Using a clip remover with its tip wrapped in protective tape, detach the clips.
Using a clip remover with its tip wrapped in protective tape, detach the clips as shown in the illustration.
Using a clip remover with its tip wrapped in protective tape, detach the clips and remove the rear door weatherstrip.
67874C
41.REMOVE REAR DOOR NO. 5 WEATHERSTRIP
Using a clip remover with its tip wrapped in protective tape, detach the clips.
Heat the rear door No. 5 weatherstrip using a heat light.
| *a | |
| *b |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
| Part | Temperature |
|---|---|
| Rear door No. 5 weatherstrip | 20 to 30°C (68 to 86°F) |
Remove the double-sided tape and Rear door No. 5 weatherstrip.
75764A
45.REMOVE REAR DOOR UPPER WINDOW FRAME MOULDING
67896
46.REMOVE REAR DOOR NO. 3 WEATHERSTRIP
Using a clip remover with its tip wrapped in protective tape, detach the clips.
Remove the clips and front door No. 3 weatherstrip as shown in the illustration.
67888F
47.REMOVE REAR DOOR NO. 2 WEATHERSTRIP
|
Protective Tape | - | - |
65923E
48.REMOVE CURTAIN HOOK (w/ Rear Door Sunshade)
|
Remove in this Direction |
|
Protective Tape |
|
Push | - | - |
67003C
49.REMOVE REAR DOOR PANEL CUSHION