| *A | w/ Double Locking System or w/ Easy Closer | - | - |
| *1 | REAR DOOR WINDOW REGULATOR ASSEMBLY LH | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the power window regulator motor assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
Use the same procedure for the RH and LH sides.
Use the same procedure described for the LH side.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL LH
68174A
6.REMOVE REAR DOOR GLASS INNER WETHERSTRIP LH
89225
9.REMOVE MULTIPLEX NETWORK DOOR REAR ECU (w/ Double Locking System or w/ Easy Closer)
67646A
10.REMOVE REAR DOOR ARMREST SET BRACKET LH
12.REMOVE HOLE PLUG
68152C
13.REMOVE REAR DOOR GLASS RUN LH
68124B
15.REMOVE REAR DOOR QUARTER WINDOW GLASS LH
69804
17.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
85720E
18.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and power window regulator motor assembly LH from the rear door window regulator sub-assembly LH.