DTC 01-D6 No Master |
DTC 01-D7 Connection Check Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| 01-D6 *1 | When either of following conditions is met:
|
|
| 01-D7 *2 | When either of following conditions is met:
|
| 1.CHECK MULTI-DISPLAY POWER SOURCE CIRCUIT |
Refer to the multi-display power source circuit (Click here).
| NEXT | |
| 2.IDENTIFY COMPONENT WHICH HAS STORED THIS CODE |
![]() |
Enter the diagnostic mode.
Press the "LAN Mon" switch to change to "LAN Monitor" mode.
Identify the component which has stored this code.
| Display | Component |
| G/W | Gateway ECU |
| DSP-AMP | Stereo component amplifier |
| AUDIO H/U | Radio receiver |
| NEXT | |
| 3.CHECK POWER SOURCE CIRCUIT OF COMPONENT WHICH HAS STORED THIS CODE |
Inspect the power source circuit of the component which has stored this code.
If the power source circuit is operating normally, proceed to the next step.
| Component | Proceed to |
| Gateway ECU (G//W) | Gateway ECU power source circuit (Click here) |
| Stereo component amplifier (DSP-AMP) | Stereo component amplifier power source circuit (Click here) |
| Radio receiver (AUDIO H/U) | Radio receive power source circuit (Click here) |
| NEXT | |
| 4.INSPECT RADIO RECEIVER |
![]() |
for 9 Speaker System:
Disconnect the R5 and R6 receiver connectors.
for 6 Speaker System:
Disconnect the R5 receiver connector.
Measure the resistance of the receiver.
| Tester Connection | Specified Condition |
| R5-9 (TX1+) - R5-10 (TX1-)*1 | 60 to 80 Ω |
| R5-9 (TX+) - R5-10 (TX-)*2 | 60 to 80 Ω |
| R6-5 (TX+) - R6-15 (TX-)*2 | 60 to 80 Ω |
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS (MULTI-DISPLAY - COMPONENT WHICH HAS STORED THIS CODE) |
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the multi-display and the component which has stored this code.
Disconnect all connectors between the multi-display and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the multi-display and the component which has stored this code.

|
| ||||
| OK | |
| 6.REPLACE COMPONENT WHICH HAS STORED THIS CODE |
Replace the component which has stored this code with a normal one and check if the same problem occurs again.
|
| ||||
| OK | ||
| ||