89661
1.INSTALL ECM (for LHD)
Install the No. 1 ECM bracket and No. 2 ECM bracket with the 4 screws.
Install the nut.
Install the ECM with the bolt and nut.
Connect the 2 ECM connectors and lower the 2 levers.
When connecting the ECM connectors, make sure that the connecting parts of the ECM connectors are free of dirt, water or other foreign matter.
Be sure to securely connect the ECM connectors.
55701J
2.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)
55815E
3.INSTALL FRONT NO. 1 VENTILATOR SEAL (for LHD)
55735B
4.INSTALL FRONT AIR SHUTTER SEAL (for LHD)
55722C
5.INSTALL INNER COWL TOP TO COWL BRACE (for LHD)
6.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for LHD)
89661
7.INSTALL ECM (for RHD)
Install the No. 1 ECM bracket and No. 2 ECM bracket with the 4 screws.
Install the ECM with the bolt and nut.
Connect the 2 ECM connectors and lower the 2 levers.
When connecting the ECM connectors, make sure that the connecting parts of the ECM connectors are free of dirt, water or other foreign matter.
Be sure to securely connect the ECM connectors.
8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
58165F
9.INSTALL FRONT FLOOR COVER RH
10.PERFORM INITIALIZATION
Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) auxiliary battery terminal.
Perform Initialization when replacing the ECM (See page Engine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>THROTTLE BODY>INSTALLATION).