Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB › from 2014.12
RM2170E _52 Drivetrain _057015 AXLE AND DIFFERENTIAL _0277999 REAR AXLE HUB G

AXLE AND DIFFERENTIAL  REAR AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When the brake pedal is first depressed after replacing the brake shoes or pushing back the wheel brake cylinder piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

·

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake shoes are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.REMOVE REAR WHEEL

Hide 42403 4.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

Hide 5.INSPECT REAR AXLE HUB BEARING LOOSENESS

a.
C249956

Using a dial indicator, check for looseness near the center of the rear axle hub.

Maximum looseness:

0.05 mm (0.00196 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly (rear speed sensor).



If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.


Hide 6.INSPECT REAR AXLE HUB RUNOUT

a.
C249957

Using a dial indicator, check for runout on the surface of the axle hub outside the rear axle hub bolts.

Maximum runout:

0.07 mm (0.00276 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to set the tip of the dial indicator towards the outside of the rear axle hub bolts.

·

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly (rear speed sensor).



If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.


Hide 42403 7.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

Hide 8.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the cable to the negative (-) auxiliary battery terminal (See page Power Source / Network>1NZ-FXE BATTERY / CHARGING>AUXILIARY BATTERY>INSTALLATION).


b.

Connect the reservoir level switch connector.