Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
55722C
2.REMOVE INNER COWL TOP TO COWL BRACE (for LHD)
55722C
3.REMOVE INNER COWL TOP TO COWL BRACE (for RHD)
55735B
4.REMOVE FRONT AIR SHUTTER SEAL (for LHD)
55735B
5.REMOVE FRONT AIR SHUTTER SEAL (for RHD)
55815E
6.REMOVE FRONT NO. 1 VENTILATOR SEAL (for LHD)
55815E
7.REMOVE FRONT NO. 1 VENTILATOR SEAL (for RHD)
55701J
8.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)
55701J
9.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
10.REMOVE FRONT WHEEL
48810
11.SEPARATE FRONT STABILIZER LINK ASSEMBLY
Remove the nut and separate the front stabilizer link assembly from the front shock absorber assembly.
Use a hexagon socket wrench to hold the stud.
47313A
12.SEPARATE FRONT FLEXIBLE HOSE
Remove the bolt and separate the front speed sensor and front flexible hose.
48684B
13.REMOVE FRONT SUSPENSION SUPPORT DUST COVER
Remove the front suspension support dust cover.
14.REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING
| *a | Wooden Block |
| *b | Jack |
Support the front lower No. 1 suspension arm sub-assembly using a jack and wooden block.
Remove the 2 nuts and 2 bolts, and separate the front shock absorber with coil spring from the steering knuckle.
When removing the nuts, keep the bolts from rotating.
Using a hexagon socket wrench, hold the front shock absorber rod and remove the nut.
Remove the front No. 2 suspension support.
Remove the front shock absorber with coil spring from the vehicle.
48609
15.REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY
48609E
16.REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
Using a hexagon socket wrench, hold the front shock absorber rod and loosen the front support to front shock absorber nut.
Using SST, compress the front coil spring.
Do not use an impact wrench. It will damage SST.
Remove the front support to front shock absorber nut.
48304
17.REMOVE FRONT NO. 1 SPRING BUMPER SUB-ASSEMBLY
Remove the front No. 1 spring bumper sub-assembly from the front shock absorber assembly.
48157C
18.REMOVE FRONT UPPER COIL SPRING INSULATOR (w/ Front Lower Coil Spring Insulator)
Shock Absorber Type A:
Remove the front upper coil spring insulator from the front shock absorber assembly.
Shock Absorber Type B:
| *1 | Front Upper Coil Spring Insulator |
| *a | Claw |
Disengage the front upper coil spring insulator from the claws of the front shock absorber assembly.
Remove the front upper coil spring insulator from the front shock absorber assembly.
48157C
19.REMOVE FRONT UPPER COIL SPRING INSULATOR (w/o Front Lower Coil Spring Insulator)
Remove the front upper coil spring insulator from the front shock absorber assembly.
48132
20.REMOVE FRONT COIL SPRING
21.REMOVE FRONT LOWER COIL SPRING INSULATOR (w/ Front Lower Coil Spring Insulator)
Remove the front lower coil spring insulator from the front shock absorber assembly.
48520
22.REMOVE FRONT SHOCK ABSORBER ASSEMBLY