1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2. DISABLE BRAKE CONTROL
3.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
55722C
4.REMOVE INNER COWL TOP TO COWL BRACE
Remove the 3 bolts and inner cowl top to cowl brace.
55735B
5.REMOVE FRONT AIR SHUTTER SEAL
Disengage the clamp to remove the front air shutter seal.
55815E
6.REMOVE FRONT NO. 1 VENTILATOR SEAL
Disengage the clamp to remove the front No. 1 ventilator seal.
55701J
7.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
Disengage the 3 clamps to separate the wire harness from the outer cowl top panel sub-assembly.
Remove the 8 bolts, nut and outer cowl top panel sub-assembly.
8.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately clean it off.
47220D
9.SEPARATE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY
Remove the 2 nuts and separate the brake master cylinder reservoir assembly from the reservoir bracket.
47235G
10.DISCONNECT NO. 2 RESERVOIR HOSE
Move the clip and disconnect the No. 2 reservoir hose from the brake booster with master cylinder assembly.
47234L
11.DISCONNECT NO. 1 RESERVOIR HOSE
Move the clip and disconnect the No. 1 reservoir hose from the brake booster with master cylinder assembly.
44572
12.SEPARATE NO. 2 BRAKE ACTUATOR HOSE
Move the clip and disconnect the No. 2 brake actuator hose from the No. 1 brake actuator tube.
47220D
13.REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY
47233
14.REMOVE RESERVOIR BRACKET
Remove the bolt, nut and reservoir bracket.
47101A
15.REMOVE BRAKE PEDAL RETURN SPRING
47264A
16.REMOVE PUSH ROD PIN
17.DISCONNECT BRAKE LINE
Using a union nut wrench, disconnect the 5 brake lines from the brake booster with master cylinder assembly.
Use tags or make a memo to identify the places to reconnect the lines.
| *a | to Front Wheel Cylinder LH |
| *b | to Rear Wheel Cylinder RH |
| *c | to Brake Booster Pump Assembly |
| *d | to Rear Wheel Cylinder LH |
| *e | to Front Wheel Cylinder RH |
Disengage the brake tube clamp from the clamp bracket of the brake booster with master cylinder assembly.
47210L
18.REMOVE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
Release the lock lever and disconnect the connector from the brake booster with master cylinder assembly.
|
Release the lock lever |
|
Disconnect the connector |
Disengage the wire harness clamp from the stud bolt of the brake booster with master cylinder assembly.
Remove the 4 nuts and brake booster with master cylinder assembly.
| *1 | Connector Portion |
| *2 | Union |
| *3 | Brake Master Cylinder Push Rod Clevis |
| *4 | Boot |
| *5 | Front No. 2 Brake Tube |
Do not kink or damage the brake lines.
Do not carry the brake booster with master cylinder assembly by the portion shown in bold in the illustration.
Be careful not to allow any brake fluid to enter the connector.
44785C
19.REMOVE BRAKE BOOSTER GASKET