Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL(for LHD)
RM2170E _54 Brake _057022 BRAKE SYSTEM (OTHER) _0278033 BRAKE PEDAL(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.

Install the brake pedal support assembly with the 4 nuts.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


b.

Engage the wire harness clamp to the brake pedal support assembly.


c.

Install the bolt to secure the brake pedal support assembly to the instrument panel reinforcement assembly.

Torque:
24 N*m (241 kgf*cm, 17 ft.*lbf)


d.

Engage the wire harness clamp to the brake pedal support assembly.


Hide 47264A 2.INSTALL PUSH ROD PIN

a.
C251272

Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal sub-assembly.

Text in Illustration
V100144

Lithium Soap Base Glycol Grease


b.

Install the push rod pin and a new clip to connect the push rod clevis to the brake pedal support assembly.

NOTICE:

Insert the push rod pin in the correct direction.



Hide 47101A 3.INSTALL BRAKE PEDAL RETURN SPRING

a.

Install the brake pedal return spring to the brake pedal support assembly and push rod pin.


Hide 45260 4.CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY

Hide 45209 5.CONNECT STEERING SLIDING YOKE SUB-ASSEMBLY

Hide 45259A 6.INSTALL COLUMN HOLE COVER SILENCER SHEET

Hide 84345 7.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 84340 8.INSTALL STOP LIGHT SWITCH ASSEMBLY

Hide 55404D 10.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 11.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 12.INSPECT AND ADJUST BRAKE PEDAL

Hide 13. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE