Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE › from 2014.12
RM2170E _54 Brake _057024 BRAKE (REAR) _0278039 REAR BRAKE FLEXIBLE HOSE A

BRAKE (REAR)  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.

·

If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.



PROCEDURE

Hide 47319F 1.INSTALL REAR FLEXIBLE HOSE

a.

Install the rear flexible hose with 2 new clips.

NOTICE:

Install the clip as far as it will go.



b.

Using a union nut wrench, connect the 2 brake lines to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt and dust to enter the brake line.

·

Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

·

This torque value is effective when the union nut wrench is parallel to the torque wrench.

·

Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




Hide 2.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 77606 3.INSTALL NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY (for RH Side)

Hide 58156 4.INSTALL FRONT NO. 4 FLOOR HEAT INSULATOR (for RH Side)

Hide 6.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)