Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2014.12–2015.11
RM2170E _55 Steering _057026 POWER ASSIST SYSTEMS _0278045 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1581/81  Assist Map Un-Writing  


DESCRIPTION

This DTC will be stored if the power steering ECU assembly determines that the assist map is not written in the ECU.

DTC No. DTC Detection Condition Trouble Area
C1581/81 Assist map not written in power steering ECU assembly
·

CAN communication system

·

Hybrid control system

·

Power steering ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.PERFORM ASSIST MAP WRITING
a.

b.

Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC C1581/81 is output A
DTC C1581/81 is not output B


NOTICE:

DTC C1581/81 is cleared after the assist map is written.



A

2.CHECK CAN COMMUNICATION SYSTEM

B

END

2.CHECK CAN COMMUNICATION SYSTEM
a.

Check for DTCs (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

3.CHECK RELATED PART (HYBRID VEHICLE CONTROL ECU)

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

3.CHECK RELATED PART (HYBRID VEHICLE CONTROL ECU)
a.

Check if any of the parts listed below have been replaced with an incorrect part in the past.

Related Part Hybrid vehicle control ECU

NOTICE:

When removing a related part to check it, be sure to follow the appropriate procedures and precautions.

Refer to the following procedures to remove the hybrid vehicle control ECU (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID VEHICLE CONTROL ECU>REMOVAL).



HINT:
·

DTC C1581/81 is stored when a part with an incorrect part number is installed for the related parts listed above.

·

When DTC C1581/81 is output when parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.




Result
Result Proceed to
All installed related parts have correct part number A
Part with incorrect part number is installed B


A

REPLACE POWER STEERING ECU ASSEMBLY

B

REPLACE RELATED PART WITH PART THAT HAS CORRECT PART NUMBER