86011R
1.INSTALL RADIO SETTING CONDENSER
Engage the claw to install a new terminal cover to the wire harness.
Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.
Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.
Do not use excessive force when inserting the wire harness into the terminal cover.
If the terminal cover has been deformed during installation, replace the terminal and terminal cover with new ones.
Engage the 3 claws to install the new terminal cover with wire harness to a new condenser.
Do not use excessive force when inserting the terminal cover into the condenser.
If the terminal cover has been deformed during installation, replace the terminal, terminal cover and condenser with new ones.
Engage the clamp to temporarily install a new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
64740C
2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
58732C
3.INSTALL REAR ABSORBER CAP LH
81330
4.INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
73370
5.CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH
64716D
6.INSTALL REAR DECK TRIM COVER
64330D
7.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
64997
8.INSTALL DECK FLOOR BOX LH
64995
9.INSTALL DECK FLOOR BOX RH
Use the same procedure as for the LH side.
58410B
10.INSTALL DECK BOARD ASSEMBLY
62332A
11.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
67918A
12.INSTALL REAR DOOR SCUFF PLATE LH
13.INSTALL REAR SEAT CUSHION ASSEMBLY (for Bench Type Seatback)
14.INSTALL REAR SEAT CUSHION ASSEMBLY (for Separate Type Seatback)
15.INSTALL REAR SEATBACK ASSEMBLY (for Bench Type Seatback)
16.INSTALL REAR SEATBACK ASSEMBLY LH (for Separate Type Seatback)
58167H
17.INSTALL FRONT CENTER FLOOR COVER
58166B
18.INSTALL FRONT FLOOR COVER LH
58165F
19.INSTALL FRONT FLOOR COVER RH
71960B
20.INSTALL REAR CENTER SEAT HEADREST ASSEMBLY
71940A
21.INSTALL REAR SEAT HEADREST ASSEMBLY