Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK › 2011.12–2015.11
RM2170E _58 Vehicle Interior _057034 DOOR LOCK _0278074 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  INSTALLATION  


PROCEDURE

Hide 69760C 1.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

Hide 69720C 2.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

Hide 69320 3.INSTALL FRONT DOOR LOCK ASSEMBLY

NOTICE:
·

When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the front door lock assembly.



a.

Apply MP grease to the sliding parts of the front door lock assembly.


b.

When reusing the front door lock assembly:

i.

Install a new door lock wiring harness seal to the front door lock assembly.



c.
B307118E03
0.552,0.76 0.677,0.76 true 0.729,0.667 0.927,0.865 0.198,0.198 10 true *1

Insert the front door lock open rod to the front door lock assembly.

Text in Illustration
*1 Front Door Lock Open Rod

HINT:

Make sure that the front door lock open rod is securely connected to the front door lock assembly.



d.

Using a T30 "TORX" socket wrench, install the front door lock assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


e.

Connect the connector.


Hide 4.INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (w/ Lock Cylinder)

Hide 67404F 5.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

Hide 68151D 6.INSTALL FRONT DOOR GLASS RUN

Hide 68102 7.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67832 8.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 67602 10.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 11.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 12.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 13.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 15.INITIALIZE POWER WINDOW CONTROL SYSTEM (for Driver Side)

Hide 16.CHECK POWER WINDOW CONTROL SYSTEM