The No. 1 air conditioning radiator damper servo sub-assembly (air mix) sends pulse signals to indicate the damper position to the air conditioning amplifier assembly. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the No. 1 air conditioning radiator damper servo sub-assembly (air mix) to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the output air.
The air conditioning amplifier assembly communicates with the servo through a communication/driver IC and wiring assembly called the air conditioning harness assembly.
Confirm that no mechanical problem is present because this diagnostic code can be stored when either a damper link or the damper is mechanically locked.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1441/41 | Air mix damper position sensor value does not change even though air conditioning amplifier assembly operates No. 1 air conditioning radiator damper servo sub-assembly (air mix). | ·
No. 1 air conditioning radiator damper servo sub-assembly (air mix) ·
Air conditioning harness assembly ·
Air conditioning amplifier assembly |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Operate the temperature adjustment switch.
Enter the following menus: Body / Air Conditioner / Data List.
Check the value(s) by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Air Mix Servo Actual Pulse(D) | No. 1 air conditioning radiator damper servo sub-assembly (air mix) actual pulse / Min.: 128, Max.: 383 | MAX. COLD: 257 (pulse)
MAX. HOT: 173 (pulse) |
- |
The display is as specified in the normal condition column.
| Result | Proceed to |
|---|---|
| NG | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| OK (When troubleshooting according to the DTC) | C |
A
B
(See pageVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>PROBLEM SYMPTOMS TABLE)
C
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Air Conditioner / Active Test.
Check the operation by referring to the table below.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Air Mix Servo Targ Pulse(D) | No. 1 air conditioning radiator damper servo sub-assembly (air mix) | Min.: 128, Max.: 383 | Operates between 173 and 257 pulses |
Air temperature changes in accordance with each control range.
OK
NG
Replace the No. 1 air conditioning radiator damper servo sub-assembly (air mix) (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new or known good one and check that the condition returns to normal.
Check for the DTC.
| Result | Proceed to |
|---|---|
| DTC B1441/41 is output | A |
| DTC B1441/41 is not output | B |
A
B
Replace the air conditioning harness assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>REMOVAL).
Since the air conditioning harness assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning harness assembly with a new or known good one and check that the condition returns to normal.
Check for the DTC.
| Result | Proceed to |
|---|---|
| DTC B1441/41 is output | A |
| DTC B1441/41 is not output | B |
A
B