1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
85720D
2.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
3.INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY
68102
4.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
67832
5.INSTALL FRONT DOOR SERVICE HOLE COVER
86160P
6.INSTALL FRONT NO. 2 SPEAKER ASSEMBLY
67602
7.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
8.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
9.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
10.CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
58165F
11.INSTALL FRONT FLOOR COVER RH
12.INITIALIZE POWER WINDOW CONTROL SYSTEM
13.INSPECT POWER WINDOW OPERATION