Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR BELT MOULDING › 2011.12–2014.12
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0278211 FRONT DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR BELT MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 68210C 2.INSTALL FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY

a.
B298000

Engage the guide and 5 claws to install the front door glass outer weatherstrip assembly.


Hide 68102 3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67832 4.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 6.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER

Hide 7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 9.INITIALIZE POWER WINDOW CONTROL SYSTEM (for Driver Side)