Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR BELT MOULDING › 2014.12–2015.11
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0278211 FRONT DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR BELT MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER

Hide 86160P 5.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY

Hide 67832 6.REMOVE FRONT DOOR SERVICE HOLE COVER

Hide 68102 7.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

Hide 68210C 8.REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY

a.
B298004E02
3.01,0.969 2.719,0.969 false 3.052,0.906 3.219,1.094 0.167,0.188 10 false *1

Apply protective tape to the door panel in the area around the front door glass outer weatherstrip assembly.

Text in Illustration
*1 Protective Tape


b.
B297999E01
1.409,2.805 1.581,2.966 0.172,0.161 10 *1 1.399,2.895 1.165,2.895 false

Using a screwdriver with the tip wrapped with protective tape, disengage the 5 claws.

Text in Illustration
*1 Protective Tape


c.

Disengage the guide and remove the front door glass outer weatherstrip assembly.